Download Print this page

HS froggit FT-Comfort Manual

Wireless indoor 8-channel thermo-hygrometer

Advertisement

Quick Links

FT-Comfort
Manual
FT-Comfort Wireless Indoor 8-Channel
Thermo-Hygrometer

Advertisement

loading
Need help?

Need help?

Do you have a question about the froggit FT-Comfort and is the answer not in the manual?

Questions and answers

Summary of Contents for HS froggit FT-Comfort

  • Page 1 FT-Comfort Manual FT-Comfort Wireless Indoor 8-Channel Thermo-Hygrometer...
  • Page 2 1. Introduction Thank you for your purchase of the FT012TH Wireless Indoor 8-Channel Thermo- Hygrometer with Display. 1.1 Indoor Thermo-Hygrometer Sensor Set Up 1. Remove the battery door on the back of the display, as shown in Figure 1. Insert two AAA (alkaline or lithium, avoid rechargeable) batteries in the back of the indoor sensor.
  • Page 3 Figure 2 1. Temperature 8. Low power indicator 2. Temperature units (°F or °C) 9. Humidity Calibrated Icon (when the 3. Temperature, Rate of Change calibration is displayed ) indicator 10. Humidity Comfort Colorful Icon 4. Temperature Calibrated Icon (when 11.
  • Page 4 2.2 Rate of Change Icon The rate of change icon detects rapid changes in temperature and humidity. If the arrow points upward, the temperature is increasing at a rate of +2°C per 30 minutes (or greater), or humidity is increasing at a rate of +5% per 30 minutes (or greater). If the arrow points downward, the temperature is decreasing at a rate of -2°C per 30 minutes (or less), or humidity is decreasing at a rate of -5% per 30 minutes (or less).
  • Page 5 To temporarily turn on the back light for five seconds, press the any button on the indoor sensor. 4 Adjustment or Calibration Note: The measured humidity range is between 10 and 99%. Humidity cannot be accurately measured outside of this range. Thus, the humidity cannot be calibrated below 10% or above 99%.
  • Page 6 Discussion:Temperature errors can occur when a sensor is placed too close to a heat source (such building structure, ground trees). To calibrate temperature, we recommend a mercury or red spirit (fluid) thermometer. Bi- metal (dial) and other digital thermometers are not a good source and have their own margin of error.
  • Page 7 Figure 5 4.5 Best Practices for Wireless Communication Wireless communication is susceptible to interference, distance, walls and metal barriers. We recommend the following best practices for trouble free wireless communication. 1. Electro-Magnetic Interference (EMI). Keep the console several feet away from computer monitors and TVs.
  • Page 8: Troubleshooting Guide

    5. Specifications 5.1 Wireless Specifications Line of sight wireless transmission (in open air): 100 meters, 30 meters under most conditions. Frequency: 433.9 MHz(+/-250K) Update Rate: 60 seconds 5.2 Measurement Specifications The following table provides specifications for the measured parameters. Measurement Range Accuracy Resolution...
  • Page 9 Problem Solution Wireless remote (thermo- If any of the sensor communication is lost, hygrometer) not reporting in to The maximum line of sight communication range console. is 100 meters and 30 meters under most conditions. Move the sensor assembly closer to the display console.
  • Page 10 We accept no liability for technical errors or printing errors, and their consequences. All trademarks and copyrights are acknowledged. www.froggit.de HS Group GmbH & Co. KG Escherstr.31 50733 Koeln Germany...
  • Page 11 Hereby we declare, HS-Group GmbH & Co.KG, Escherstr. 31, 50733 D-Cologne, that this product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5 / EC. The declaration of conformity for this product can be found at: www.froggit.de or on...

This manual is also suitable for:

Froggit ft012th