Advertisement
Available languages
Available languages
Electrical Connection and Start-up
1.
Connect the 24VDC power supply to the
mains (230VAC)
4.
Wiring of the inputs/outputs
Parameterizing-Software
Device parameters such as output voltage, permissible voltage
range, general error a.s.o. can be adjusted with the paraTEC
software.
Please ask for further information!
ATTENTION! The safety notes of the operating instructions have to be regarded.
Installation and wiring work may only be carried out by qualified electricians.
The sheet „Quickstart" is only a support.
2.
Connect the C-TEC P to the output of
24VDC power supply
5.
Switch on the power supply.
The C-TEC P is charging.
The LED „Netz/Mains" illuminate
The TECControl-Software automates the system-shutdown at
power failure and the controlled system-restart after
power recovery.
Please ask for further information!
Helmholtzstrasse 13
77652 Offenburg
Werner-von-Siemens-Strasse 12
77656 Offenburg-Elgersweier
3.
Connect the load to the buffered
24VDC output of the C-TEC
6.
C-TEC is completely charged.
The LEDs „Netz/Mains" and „U /V >"
illuminate
Shutdown-Software
C
cap
Phone +49 (0)781 / 206-0
Fax
+49 (0)781 / 2 53 18
www.j-schneider.de
info@j-schneider.de
Advertisement
