LG ATNH09GRLE2 Svc Manual page 31

Part 2 Functions & Controls
This is the function that decides the strength of the wind for each wind level and because this function is to make the installation
easier.
• If you set ESP incorrectly, the air conditioner may malfunction.
• This setting must be carried out by a certificated-technician.
Function code,
ESP code
ESP value
• When setting ESP value on the product without very weak wind or power wind function, it may not work.
Function code, ESP code
ESP value
•
Please be careful not to change the ESP value for each fan step.
•
It does not work to setup ESP value for very low/power step for some products.
•
ESP value is available for specific range belongs to the product.
Copyright ©2013 LG Electronics. Inc. All right reserved.
Only for training and service purposes
If pressing button long for 3 seconds, it enters into remote
1
controller setter setup mode.
- If pressing once shortly, it enters into user setup mode.
Please press more than 3 seconds for sure.
2 If entering into ESP setup mode by using
the picture below.
3
Select ESP fan step by pressing
03: medium, 04: high, 05: very high)
Move to ESP value setting by pressing
4
(It is 000 when delivering
from the warehouse.)
Press button to setup ESP value.
5
(It is possible to setup ESP value from 1 to 255,
and 1 is the smallest and 255 is the biggest.)
Select ESP fan step again by using
6
No. 4 and 5, that corresponds each wind flow
Press button to save.
7
8 Press button to exit.
❈ After setup, it automatically gets out of setup mode if there is no button
input for 25 seconds.
❈ When exiting without pressing set button, the manipulated value is not
reflected.
- 31 -
button, it indicates as
ESP step
Function Code ESP value
button. (01: very low, 02: low,
button.
button and setup ESP value, as
LGE Internal Use Only