Advertisement
Quick Links
Advertisement
Summary of Contents for Tabi Aura
- Page 1 Doc # 100121 | Rev A Page 1 of 8...
-
Page 2: Safety Requirements
Tabi aura - Wall Mounted Frameless Dry Erase Verify Wall Construction Board, Non-Seismic Applications • CAUTION! Adequate wall construction is required The building’s Engineer of Record must be to support the weight of the board. Minimum wall consulted to determine if there are any seismic construction must be capable of supporting weight requirements. - Page 3 Anchors/ Size / Orientation Brackets Screws Provide adequate protection for finished floor surfaces. 47” x 48” 2. All Aura installations should be carried out by two or 47” x 72” horizontal more individuals. 47” x 72” vertical 47” x 96”...
-
Page 4: Installation Instructions
# of studs Weight Use appropriate mounting specification based on the size Size and the orientation of your Aura board 34 lbs 47” x 48” NOTE: You may drill holes in the support bracket to 47” x 72”... - Page 5 installation instructions step two Level brackets and mark holes onto wall. Refer to recommended mounting heights noted on page 4. brackets step three marked hole anchors Remove brackets from wall and install wall anchors in all hole locations that are not over a stud.
- Page 6 Re-align brackets with holes and secure using screws. screws step five Lower brackets on back of the Aura board onto brackets on wall. IMPORTANT: Always check to insure both top and bottom panel brackets are resting on the wall brackets.
- Page 7 NOTE: Consider using glass suction cups when mounting panel. Installation of Aura is now complete. Page 7 of 8 | Doc # 100121 | Rev A...
- Page 8 PolyVision Corporation reserves the right to make changes in product design, construction or detail, and to discontinue any product or material without tabiforteams.com notice. Tabi products are manufactured by PolyVision Corporation. Doc # 100121 | Rev A Page 8 of 8...