MUSE MUSE To hold pressed the button centrally located To hold pressed the button on the upper side of the casing for 1 sec. until the blue led goes off The blue led start blinking and the system is ready...
Page 3
It allows for data log within flash memory It allows for remote control Configure LOG Mode Run Muse Viewer → Connect the device → Settings → Configuration… Select Tab Logger → Set Log Mode / Frequency → Click Apply and Exit Disconnect and turn off the device N.B.
Page 4
Turn on the device by holding down the power on button for at least 5 sec. → The blue led starts blinking slowly → The system is ready When the device is in FOTA Mode, it can be remotely controlled by using only the Firmware Update Tool provided with the Muse Viewer software application...
Page 5
LIGHTS Acquisition state Download data Low battery level Battery charging To recharge the battery, connect the USB cable or bring the device near the wireless charging docking station → The white led slow blinks Fully charged → The white led remains stationary...
INFORMATION AND WARNING MUSE system uses a right-handed coordinate system, where MUSE uses a rechargeable lithium-polymer battery and the x-axis is outgoing with respect to the USB, while the z-axis includes circuitry for both thermal and electrical protections is outgoing with respect to the power on/off button.