Elite Tents Moonbounce Setup And Take Down Instructions

Hide thumbs

Moonbounce Set-up and Take-down

Important Note: Please use caution when lifting bounces, they weigh between 175 to 250

pounds depending on the size of the bounce. Do not attempt to lift with one person.

Step1: Find a flat level area (preferably a

grassy area). Make sure there are no overhead

electric power or telephone lines. Location

should be free from trees and unobstructed

area should be maintained for 5 feet around

the perimeter of the inflatable. Police the area

you are going to set-up the moonbounce on for

sticks, glass or anything else that may

puncture the bounce. Place the bounce on the

ground where you want the back of the unit to

be. Un-hook the strap and place it somewhere

it won't get lost.

410-795-8368

Instructions

How to Set-Up Bounce:

Step 2: Roll out the bounce.

6335 S. Carroll Park Drive, Sykesville, MD 21784

Table of Contents

Need help?

Do you have a question about the Moonbounce and is the answer not in the manual?

Questions and answers

Summary of Contents for Elite Tents Moonbounce

Page 1 5 feet around the perimeter of the inflatable. Police the area Step 2: Roll out the bounce. you are going to set-up the moonbounce on for sticks, glass or anything else that may puncture the bounce. Place the bounce on the ground where you want the back of the unit to be.
Page 2 VERY IMPORTANT - Step 4: After bounce is opened fully, check to see if there are any Velcro Ports that need to be closed. Seal the Velcro port by making sure the Velcro port is flat and closed tightly. Some bounces have a Step 3: Un-fold the bounce until it is flat.
Page 3 VERY IMPORTANT -Step 7: Pull strap until it is tight. If the strap is not tight enough Step 6: Wrap black strap around the outside of it will separate from the blower and come off. the inflation tube and feed the end of the strap It is very important to check the strap after the through the metal teeth of the clip.
Page 4 SAFETY NOTICE Step 10: After bounce is fully inflated, place Step 11: Read load capacity label on the the large stakes through the ring that is bounce. Do not exceed the load capacity of attached to each corner of the bounce by a the bounce.
Page 5 How to Take Down a Bounce Step 1: Remove stakes from corners of the Step 2: Continue to step on bounce to get the bounce. Turn off the blower. Disconnect the air out. Pull all of the sides into the middle of inflation tube from the blower.
Page 6 Step 5: Fold the left side of the bounce to the Step 6: Fold the left side on top of the right middle of the bounce. side. Step 7: Step on the bounce to flatten the Step 8: Make sure that all ports, ropes, or bounce out and squeeze any remaining air in hanging parts are tucked into the bounce.
Page 7 * Please make sure you return all Parts to Elite Tents and Events including Bounce, (4) Stakes, Extension Cord, and Blower. Customers will be charged $50.00 for bounces that are brought back wet or dirty.