Table of Contents
Advertisement
USE
WARNING: The first use of the equipment after installation or maintenance must be done on a trial basis
and regulation of all parts and accessories using tissues or garments not important. Some parts of the
machine may leave halos or spots as used for the first time. This situation may also not occur but is not a
fault.
1) Open the on-off valve of the water supply.
2) Turn on the main switch of the machine.
3) Press the boiler button.
4) The warning light of the water supply switches on automatically (the water starts running into the boiler).
5) Once the water has reached the required level the relevant warning light switches off automatically, whereas the
one of the boiler heater turns on.
6) After a few minutes the boiler reaches the working pressure of 2.6 bar (check the pressure on the pressure
gauge), the relevant warning light switches off automatically.
7) The generator is now ready to supply steam.
8) Adjust the board temperature by means of the thermostat wheel.
9) Wait until the boards reach the required temperature.
10) Push the pedal to put the air suction on boards into operation.
11) At the end of the work, turn off the table by means of the relevant buttons.
USE OF THE SLEEVE SHAPE
12) By drawing the sleeve shape towards the ironing surface, Push the pedal for the vacuum operation.
USE OF THE STEAM IRON TYPE "U"
13) Turn on the iron switch.
14) Switch on the iron a few minutes before you start working, until the soleplate has reached the adjusted
temperature.
15) In case the temperature of the soleplate has to be kept very high, we recommend to apply a Teflon® shoe in
order to prevent burns of the garment.
USE OF THE STEAM-AIR GUN
16) Place the garment to be treated onto the spotting shape, making sure that it lies exactly on the vacuum part.
17) Push the vacuum pedal; by turning the condensation-jet of the gun first towards a tank until only steam comes
out.
18) Draw the gun closer to the part to be treated, by pushing at the same time both the vacuum and the steam
pedal.
19) Once the stain is dissolved, dry the treated part by pushing simultaneously the vacuum pedal and airbutton on
the gun.
11 - HAZARDOUS USE
The conformity verification, according to the essential safety rules and to the provisions of the machine directive,
has already been carried out by filling out the specially provided checking lists that are included in the technical file.
The checking lists are of two kinds:
List of dangers (drawn from EN 1050 referring to EN 292)
Application of the main safety features (Machine Directive– appendix. 1, part 1)
The dangers described in the following have not been completely removed, but they have been deemed to
be acceptable:
During the maintenance operation there could be some steam jets at low pressure, (maintenance
operation must therefore be carried out by using suitable protection devices)
The user must provide for a protection against direct and indirect contacts.
-
SAFETY SHOES.
-
VISOR FOR PROTECTION.
-
PROTECTIVE GLOVES.
7
Advertisement
Table of Contents
