Advertisement
Quick Links
Stand Alone or Extender Installation
Parts:
Box 1
Room Divider Panel x1
1
Please read all instructions before installation. Start by laying the Room Divider Panel on a large, at,
stable surface. Find the pre-drilled holes in the bottom of the divider. Take the set of feet that came with
the product and slide them in until the round disk on the foot is up against the Divider Panel.
Instructions for the RECLAIM™ Room Divider Panels
Box 2
Flat Feet x2
(Stand Alone)
* Please note: The foot type included in box 2 depends on SKU ordered.
Or
Flat Foot x1
Peg Foot x1
(Extender)
LuxorFurn.com/Reclaim
Advertisement
Summary of Contents for Luxor Reclaim
- Page 1 Instructions for the RECLAIM™ Room Divider Panels Stand Alone or Extender Installation Parts: Box 1 Box 2 Flat Feet x2 Flat Foot x1 Peg Foot x1 Room Divider Panel x1 (Stand Alone) (Extender) * Please note: The foot type included in box 2 depends on SKU ordered.
- Page 2 Very carefully rotate Divider Panel o of at surface into a standing position on the oor. For best results, make sure feet are at and even against the oor. LuxorFurn.com/Reclaim...
- Page 3 Next, nd the zipper tabs and make sure they are at the top of the Panels. Zip the Panels together by pulling the zipper tabs from the top of the panel all the way to the bottom of the zipper. LuxorFurn.com/Reclaim...
- Page 4 Once the Panels are zipped together, gather the sets of feet for the Panels. Slide the feet in until the round disk on the foot is up against the Divider Panel. Please note the foot placement shown below. The Flat feet need to go on the outside of the end Panels for optimal stability. LuxorFurn.com/Reclaim...
- Page 5 With help, very carefully rotate Divider Panel o of at surface into a standing position on the oor. For best results, make sure feet are at and even against the oor. Assistance Recommended LuxorFurn.com/Reclaim...