Summary of Contents for Paw Brothers PBP89440C
- Page 1 Paw Brothers ® Professional Hybrid Cage PBP89440C Assembly Instructions Copyright © 2013, G & G Distribution, Inc. All Rights Reserved...
- Page 2 Initial Inspection When your Paw Brothers® Professional Hybrid Cage arrives, check immediately for signs of shipping damage. If you notice damage, save the shipping carton for claim purposes, and im- mediately report the problem to your supplier and to the shipping company.
- Page 3 Assembly Instructions: Step 1. Unpack all cage parts and compare all the pieces to the parts list. Step 2. Using a #3 Phillips screwdriver, put one 26” X 31.5” panel and one 26” X 43.75” panel together with sheet metal screws. The flanges face out as shown in Figure A below. Step 3.
- Page 4 Step 6. Install the Divider Panel Holder onto the Back Panel with two screws. Assemble the Back Panel to the cage making sure the Divider Panel Holder is placed in the right direction as shown in Figures F and F1. NOTE! For proper panel alignment, do not completely tighten the screws on the back panel until each hole has a screw inserted.
- Page 5 Installation of the Divider Panel Extension Bar The divider panel extension bar is needed whenever the floor grates and pans are not used. The divider panel, when used, will slide on top of the extension bar. Install the divider panel extension bar (Figure 1) as shown in Figures 2 and 3.
Need help?
Do you have a question about the PBP89440C and is the answer not in the manual?
Questions and answers