Operation - GE 4PE350A3 Instructions Manual

EBI-6351
COLOR CAMERA
certain that the cable plug is not tipped or
off -center when inserted.
Zoom Lens Extenders
The installation and/or setting of a lens
extender (to be done only after tracking the
zoom without an extender has been com-
pleted) is accomplished as follows:
1. Remove the lens access cover (in the
top of the shroud).
2. Loosen the two thumbscrews (acces-
sible through slots in the bottom of the shroud
on the lens mount.
3. Slide the lens forward.
4. Insert the extender by threading onto
the rear of the zoom lens (internal thread
on the extender).
5. Slide the lens with the extender towards
the Camera case so that the extender seats
against the casting.
6. Move the zoom control so that the
lens is at wide angle.
7. Rotate the positioning nut on the ex-
tender until the image is in focus and the
shoulder of the extender is seated against
the Camera casting.
8. Lock down, using the three set screws
in the extender positioning nut.
9. Check the tracking from wide angle to
narrow angle.
Refer to Figs. 12, 13, and 14.
CAUTION
10. Tighten the lens mount thumbscrews.
11. Reassemble the lens access cover.
NOTE
Follow these procedures for both
the
2X
and
3X
extenders
(PL -7782019G1 and G2). This set-
ting should not change unless the
extender is mated with a different
zoom lens.
When the sunshade is used, re-
move the lens cover. The sunshade
slips over the lens.
Filter Disk
The eight filters associated with the filter
disk are held in place by flat bar spring
tabs. The filter is slipped under the spring
tab and seats
in the retaining shouldered
groove.
It
is recommended that lint -free
gloves be used so that fingerprints will not
smudge the glass.
OPERATION
PRIOR TO OPERATING THIS
EQUIPMENT, STUDY THE CON-
TENTS OF THIS SECTION PAYING
PARTICULAR ATTENTION TO THE
PURPOSE OF THE VARIOUS CON-
TROLS AND INDICATORS AS WELL
AS TO THE NOTES, CAUTIONS,
AND
WARNINGS.
OPERATORS
SHOULD BE AWARE THAT AT-
TEMPTS TO SHORTCUT PROCE-
DURES AS OUTLINED IN THIS SEC-
TION WILL GENERALLY RESULT
14
NOTE
Lint -free gloves may be ordered
from Neumade Products Corpora-
tion, 9-16 37th Avenue, Long Island
City, New York, 11701.
IN SUBSTANDARD PERFORMANCE
AND CAN CAUSE DAMAGE TO THE
EQUIPMENT.
The following operating procedures should
be adhered to sequentially during the initial
operation of this equipment.
CAUTION
TURN THE FOUR BEAM POTEN-
TIOMETERS, W,
R,
B, AND G,
COUNTERCLOCKWISE FOR BEAM
CUTOFF. THE IRIS DELEGATE
SWITCH IS IN THE LOCAL POSI-
TION.