Advertisement
7) The FTW The Hybrid Cooling Kit's waterblock uses a pass-through cable to power the pump on the waterblock and the fan
on the graphics card. Using the pictures below as a guide, (1) plug the fan's power connector into the waterblock's female
pass-through connector, then (2) connect the remaining connector into the graphics card's fan header. Once all connectors
are attached, please use the included strips of tape to secure the wires to the plastic around the perimeter of the fan; the
wires must not come into contact with the fan. Lastly, install the three washers at the end of the card by placing the adhesive
side on the PCB.
Advertisement
