WECHEER Pro Engraver WE 258 Series Quick Start Manual

Thank you for purchasing WECHEER professional power tool.
WE 258 is a light, precise, highly flexible and user-friendly product designed for carving,
engraving, routing, grinding, sharpening, sanding, polishing, drilling and other similar
tasks.
This device can operate in both directions, has precise variable speed, and protective
mechanisms such as overload protection (if overload protection is triggered and the motor
is shut down, turn off the motor for 1 minute to reset).
This device utilizes direct current to ensure safe operation in a wide range of
environments.
The handpiece is designed for both right-handed and left-handed users.
Slower speeds are recommended for polishing operation. Higher speeds are better for
carving, drilling, cutting, routing and shaping. Hardwoods, metals and glass generally
require high-speed operation.
Please feel free to contact your local suppliers for our other fine tools and accessories.
SPECIFICATIONS
INPUT
OUTPUT
RPM
HANDPIECE DIA.
CAPACITY
OPERATION
To remove/change/insert a bit:
1. Turn off and unplug the device.
2. Rotate the front part of the handpiece until the dot aligns with
the "R" (it will snap into position)
3. Remove/change/insert the bit.
4. Rotate the front part of the handpiece until the dot aligns with
the "S" before turning on the unit.
With the speed control (without a foot pedal):
1. Make sure the power switch is off.
2. Select the desired direction (forward or reverse).
3. Insert/change to the bit you wish to use per the instructions above (make sure the
dot is aligned with the "S" before turning it on), and plug the handpiece into the
Pro Engraver
WE 258 SERIES
AC 110V ~ 120V or 220V ~ 240V 50/60 Hz
24V , 10W
Variable Speed: 2,000 ~ 30,000 RPM
3/32" (2.4 mm) for 25800, 02, 04, 06
1/8" (3.2 mm) for 25801, 03, 05, 07
26mm