Advertisement
speed control unit.
4. Plug the speed control unit into a wall outlet.
5. Turn on the device and adjust the speed as required.
With the speed control and an ON/OFF foot pedal
(WE25703/25704):
1. Make sure the power switch is off.
2. Connect the foot control to the speed control unit using the parallel blades
connector
(WARNING: IT IS NOT A POWER PLUG. DO NOT PLUG INTO THE
WALL).
3. Select the desired direction (forward or reverse).
4. Insert/change to the bit you wish to use per the instructions above (make sure the
dot is aligned with the "S"), and plug the handpiece into the speed control unit.
5. Plug the speed control unit into a wall outlet.
6. Leave the power switch off, use the foot control to turn the device on and off, and
adjust the speed using the speed control unit as required.
With the speed control and a variable-speed foot pedal (WE25701/25702):
1. Make sure the power switch is off.
2. Plug the speed control unit into the female socket on the foot control.
3. Plug the foot control into a wall outlet.
4. Insert/change to the bit you wish to use per the instructions above (make sure the
dot is aligned with the "S"), and plug the handpiece into the speed control unit.
5. Move the power switch on the speed control unit to on, and set the speed to max.
6. Use the foot control to control the speed of the motor.
SAFETY CONCERNS
Please make sure that the voltage of your wall outlet matches the required voltage.
•
Always unplug the tool before swapping or loading accessories, or bits.
•
Keep dust out of eyes and lungs by using a protective eyewear or a dust mask.
•
Always unplug after use.
•
Do not use damaged bits, which can be dangerous.
•
MAINTENANCE INSTRUCTION
Frequently clean the body with soft cloth or air compressor to avoid the dust from
preventing the tool from running smoothly. Never use cleaning solvents or detergents.
For more information and/or technical support, please visit our website at:
http://www.wecheer.com or contact us at:
service@wecheer.com
Advertisement
