LG ANNQ60GKA4 Installation Manual page 17

3
Please fix remote controller upper part into
the backplate attached to the surface of
the wall, as the picture below, and then,
connect with backplate by pressing lower
part.
- Please make sure to leave no gaps on the
top, bottom, left or right sides between
the remote controller and backplate.
- Before assembly with the backplate,
arrange the Cable not to interfere with
circuit parts.
<Connecting order>
Wall
Side
Remove remote controller by inserting a
screwdriver into the lower separating holes
and twisting to release the controller from
backplate.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the
inside components when separating.
<Separating order>
Wall
Side
4
Please refer to the following directions
when connecting the indoor unit and the
wired remote controller together.
- Please connect the cables as shown in
the figure below when connecting the
plug type cable from the indoor unit's
C/BOX and the housing type of the
extension cable.
FAN
SPEED
TEMP
Wall
Signal
Side
GND
!
• Specification of LG supplied extension
cable: AWG#22, 3 core shielded.
(Model : PZCWRC1)
* Apply enclosed noncombustible
- When connecting Terminal Blocks of the
indoor C/BOX and the wired remote
Wall
controller with the extension cable, refer
Side
to the steps below.
① Remove the screw on the cable which
② Remove the housing of the provided
INSTALLATION INSTRUCTION
Please check if the connectors
are connected properly.
C/BOX Cable (Plug type)
OPER
MODE
Extension cable(housing type)
Yellow
12 V Red
Black
CAUTION
conduit(metal raceway) totally or use
FT-6 rated cable or above level in case of
local electric & building code that
requires plenum (CMP) cable usage.
is fastened to the wired remote
controller's Terminal Block by loosening
with a screw driver.
32ft extension cable with a cutting
nipper and peel it as shown in the figure
below. (when purchasing the extension
cable at the site directly, please peel it
as shown in the figure below.)
0.394 inch(10 mm) ± 0.118 inch(3 mm)
17
Indoor
Unit side