OptConnect OptReboot Setup Manual

OptReboot works seamlessly with an existing OptConnect cellular gateway, enabling
you to remotely reboot your ATM, Kiosk, Point of Sale, or any other similar device from
an internet connected computer, tablet, or smart phone. Your OptReboot comes
pre-configured and simply needs to be connected using the included cabling.
Open the ATM's lower cabinet to access the ATM's and OptConnect gateway's power
supply. The OptReboot is designed to be installed in this lower cabinet.
Locate An Available Ethernet Port: Looking at the back of the OptConnect cellular
gateway, determine if you have an open ethernet port.
If the ethernet port is already occupied by a connection to an ATM, Kiosk, or other
device, continue to step 3a. If the port is available, skip directly to step 3b.
Connecting Network Connections
3a Connect Using A Network Switch: These steps are required only if your OptConnect
gateway's ethernet port is occupied. The OptReboot is compatible with any network
switch (one may have been included in your shipment).
a) Disconnect your ATM, Kiosk, or other device from the OptConnect gateway.
Network Switch
ETHERNET
STATUS
S
CELL I
RESET G
ON
N
A
L
OptConnect Gateway
Network Switch
b) Connect your
device's ethernet
cable to a port on a
network switch.
d) Connect an
ethernet cable
between the
OptConnect
gateway and the
networt switch.
Network Switch
OptReboot
See overall Network Connection diagram on back.
c) Connect an ethernet
cable between
the OptReboot's
ethernet port and a
port on the network
switch.