All rights reserved. No part of this publication may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopy, recording, or any information storage and retrieval system, without permission in writing from the publisher. Requests should be mailed to RAVE Sports, 3325 Labore Road, Saint Paul, MN 55110.
If you have any questions regarding this product, please call RAVE Sports at 1-800-659-0790, or visit www.ravesports.com. W A R N I N G UNSAFE USE OF THE TURBO CHUTE CAN RESULT IN PERSONAL INJURY OR DEATH. To reduce the risk of injury, read and follow all instructions and warnings in this manual.
• Because of their larger size, older children and adults risk spine, neck, head or other life-threatening injuries when using this slide. • The Turbo Chute is designed to be used only on grass or into a lake that allows for safe usage and with sufficient water depth to ensure safety.
Page 5
• Proper setup by an adult is required. • DO NOT use if any part of slide is damaged or incorrectly attached. • When not in use, deflate Turbo Chute and store in a secure area. Never leave slide inflated and unattended.
Page 6
• Ensure pool reservoir attachment is situated on flat ground. NEVER place reservoir on a downward slope. • Over running the pool reservoir may result in injury. Adjust location, if necessary, and maintain proper water depth in pool in order to avoid over running the pool.
Ensure that the entire length of the chosen slide path is free of rocks, bumps, depressions, sticks, etc., and the surface beneath the Turbo Chute is either smooth grass or sand. A minimum of 7 °...
Page 9
Align valve with hole in the cover of the side rail. Inflate bladder 50% full and check to ensure bladder is not twisted and valve is properly aligned with the hole in the cover. Adjust the bladder if necessary. Inflate side rails to firm but not hard. Inflating the product too firm initially can make it difficult to join the sections together.
Page 10
Attach each straight Turbo Chute section so that the warning label is positioned on the lead (uphill) end of the slide. Ensure all Velcro® strips are securely fastened together and there is a smooth transition from section to section without gaps.
Page 11
10 degrees in slope. 4. Ensure there is a smooth transition from land to water. Excavate, use fill sand or other means of creating this smooth transition. Add additional Turbo Chute sections if slide is too short to meet the criteria above.
Page 12
2. The Inflatable Start Mat should be situated at the beginning of the slide on a level or slightly downward sloping surface of no more than 10 degrees in slope. Add additional Turbo Chute sections if slide is too short to meet the criteria above.
Page 13
DO NOT STAND, KNEEL, CROUCH OR ATTEMPT TO USE SLIDE WITHOUT TURBO SLED. Ensure slide, Splash Pool, and/or water (if using in a lake) at the end of the Turbo Chute are clear of obstructions and other people before going down slide.
NOTE: Sliding performance on any slope can be enhanced with the following techniques: 1. Increase the volume of water being applied at the top of the slide. 2. Use environmentally friendly liquid dish soap. Squirt soap onto top of slide and bottom of sled periodically as needed. 3.
Troubleshooting Air chambers won’t hold air: • Check to make sure all valves are completely closed. • Check for holes in the slide following the procedures in the “Repairs” section. Repairs Additional repair patches can be purchased at www.ravesports.com. For Minor Holes or Punctures: ...
Page 16
RAVE Sports A Revel Match, LLC Company 3325 Labore Road Saint Paul, MN 55110 800.659.0790 February 2012...