Table of Contents
Advertisement
Quick Links
INDUSTRIAL VACUUM CLEANER EN
PARTS OF THE TOOL
1 Upper hose nozzle
2 Handle
3 On/Off
4 Front hose nozzle
5 Handle
6 Power cord
7 Head lockers
8 Water tank
9 Pneumatic tool connection
10 Electric tool socket
11 Speed control
12 Rubber cap
13 Castor wheels with lock
14 Operating air outlet
15 Compressed air inlet (not shown)
Identification plate (not shown)
14
Picture 1
1
15
1
9
11
10
12
13
Advertisement
Table of Contents
Summary of Contents for 4CR 9500
- Page 1 INDUSTRIAL VACUUM CLEANER EN Picture 1 PARTS OF THE TOOL 1 Upper hose nozzle 2 Handle 3 On/Off 4 Front hose nozzle 5 Handle 6 Power cord 7 Head lockers 8 Water tank 9 Pneumatic tool connection 10 Electric tool socket 11 Speed control 12 Rubber cap 13 Castor wheels with lock...
- Page 2 INDUSTRIAL VACUUM CLEANER EN...
-
Page 3: Technical Data
INDUSTRIAL VACUUM CLEANER EN TECHNICAL DATA PICTOGRAMS Operating voltage and frequency 220-240 VAC - 50/60 Hz Read the following instruction first before operating the product Power 1600 W 2000 W, Сlass 1 Power at socket (max) Important safety indications Total power (max) 3600 W Air capacity 119 m... - Page 4 INDUSTRIAL VACUUM CLEANER EN Loose clothes, jewellery or long hair can be caught in moving parts. g) If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. EQUIPMENT USE AND CARE a) Do not force the equipment.
-
Page 5: Specific Use
INDUSTRIAL VACUUM CLEANER EN - Do not vacuum sanding dust from surfaces treated with paints that have not completed the catalyst cycle; - Do not vacuum sparks or white hot shavings; - Immediately disconnect the vacuum from the electrical mains if dust is ejected from air outlet; - Do not vacuum flammable or explosive liquids (i.e. -
Page 6: Machine Use
INDUSTRIAL VACUUM CLEANER EN - Check for the tool switch turned off before connecting it to the front panel quick coupling; - Connect the tool to the appliance with the quick couplings (Pos. 15, Picture 1) and (19); - Connect the coaxial hose (optional) to the quick coupling (Pos 18, Picture 1). - Check the tool functioning as indicated on their instructions manual. - Page 7 INDUSTRIAL VACUUM CLEANER EN Only use genuine HUBERTH dust bags. Spare bags shozuld be kept in dry places! Follow local legal regulations for disposal. FILTER REPLACEMENT Do not spread dust during filter replacement! - Removing the upper part of the vacuum cleaner (12) To remove the upper part, open two latches and pull the upper part of the vacuum cleaner by the handle.
-
Page 8: Troubleshooting And Solution
INDUSTRIAL VACUUM CLEANER EN TROUBLESHOOTING AND SOLUTION EFFECTS CAUSES SOLUTIONS The motor will not start No power Make sure the unit is plugged in Power cord, switch or motor defective Contact an authorised service centre The vacuum does not start Electronic module Contact an authorised service centre automatically...