Pelvital Flyte MTI-1 Quick Start Manual

SIDE 1
Quick Start Guide
In-Home Pelvic Floor Treatment Model MTI-1
1
Check it out.
Visually inspect the device
before use for anything
unusual (cracks, tears,
exposed wires).
Choose place &
4
position.
Choose a private area
where you will be able to
concentrate solely on the
exercise for 5 continuous
minutes.
Choose either a standing or
sitting position to use the
device for the duration of the
5-minute therapy. For best
results, you should remain still
in the same position for the
full 5 minutes.
WARNING: Do not submerge the biofeedback unit, the
charging cable, the wall charger, or the wand in water.
Please review the Instructions for Use, included
with the Flyte™ system, for complete information.
2
Charge it.
Before use, charge the device by plugging the USB
cable into the receptacle on the biofeedback unit. Plug
it into the wall. You will know Flyte™ is charging when
the charging light is yellow.
When the charging light turns off, the device is fully
charged and you should disconnect and store the
charging cable and unit. A full charge will take at least
2.5 hours. Pelvital recommends that you recharge the
battery weekly.
5 Insert the device. 6
Apply a small amount Once the wand is inserted
in your vagina, plug the
of water-based vaginal
lubricant to the wand or connector on the end
apply a lubricated probe of the wand into the
cover. Get into position biofeedback unit. Turn
and fully insert the wand Flyte™ on by pressing
into your vagina, with the On/Off button on
the longer wing facing the bottom center of the
the front of your body. If device for one second.
you encounter excessive The product is on when
discomfort, remove the the green "On" indicator
wand and contact our light is displayed.
customer care team
at 1-866-PELVITAL or
support@pelvital.com.
3
Clean & disinfect it.
Clean and disinfect the wand before its first use, after
each use, and again before each subsequent use.
Unplug the wand from the biofeedback unit prior to
cleaning the product.
To clean the wand, complete the following steps:
• Wash your hands.
• Use a clean, damp cloth to remove any obvious
residue from the wand.
• Hand wash the wand with mild soap and water.
• Rinse the wand thoroughly with warm water.
Plug in & turn on.
To disinfect the wand and biofeedback unit,
complete the following steps:
• Dispense a hypochlorite wipe from its container.
• Use the wipe to disinfect the wand and biofeedback
unit, wiping all outside surfaces thoroughly
according to the instructions included with the
wipes.
• Discard the wipe
• Allow the wand's surface to remain wet for 5
minutes.
• Use a clean, damp cloth to wipe the wand clean
and remove residual disinfectant.
USING THE DEVICE (SIDE 2)