Gravity 8G-1000 Possible configurations: ® 8-ch mode: Thank you for buying this XETEC product and thank you for your 8 Channels each with 83 Watts into 4 Ohms or 130 Watts into 2 Ohms confidence! 6-ch mode: With this XETEC product you have purchased an innovative and...
Page 4
How to configure the amplifier Normal operation: First you should decide (perhaps with the help of your local XETEC Every amplifier is only capable of driving loads (speakers) up to a certain dealer) which configuration fits best to your car-audio solution.
Page 5
Configuration Configuration Input & gain Input & gain control mode module control mode module Output Power Output Power Speaker Speaker into 4 Ohm into 2 Ohm into 4 Ohm into 2 Ohm Channels 1-4 Channels 1-4 CH 1 single CH 1 83 Watt 130 Watt CH 1...
Be careful when drilling holes, there might be wires, fuel lines or the gas tank behind a wall! Never drill holes when you do not XETEC proposes the following minimum gauges: know what´s behind. Never install signal wires close to power cables to avoid hum and alternator noise is being induced.
4. Alternator whine and similar noise · Bad ground connections? · Use ONE ground contact only! · RCA cables run too close to power cables? In case of further trouble, please ask your local XETEC dealer for support. – 8 –...