Summary of Contents for Englefield Flat Shower Wall
Page 1
INSTALLATION INSTRUCTIONS • Flat Shower Wall • Side Contour Wall • Corner Contour DURACYL WALL • Flat Bath Wall • Corner Contour Wall PLUS Wall CORNER CONTOUR PLUS CORNER CONTOUR BATH WALL Englefield has a history of making superb showers...
Page 2
Jigsaw (fine blade) Caulking gun Drill Spirit level Fine toothed saw Hole saw BACKED-OFF CUTTING EDGE Drill bits Use only recommended sealants and adhesives, suitable on acrylic and acrylic capped ABS; unsuitable products may damage the Duracryl wall. IMPORTANT ENGLEFIELD Page 2...
Page 3
Sealants Packs. Each Pack contains enough adhesive and sealant for a complete shower enclosure or shower over bath installation. For stockists phone 0800 100 382 (NZ) or 1800 ENGLEFIELD (Australia). 16520A-0 Adhesive & sealant pack - 2 sided wall liner for white framed showers.
Page 4
CONSTRUCTION REQUIREMENTS - TIMBER FRAME 1) For showers, identify the type of installation required and construct timber frame in accordance with below. Englefield recommends installing double studs to fix the wall retainers to. A typical shower enclosure timber frame is shown in For the framing of bath tubs and screens, please refer to the installation guide supplied with the product.
Page 5
With a soft pencil, mark around the perimeter of the wall liner. This will be the basis for marking the Fig.5: Mark and drill holes for plumbing glue pattern as per Fig.8: Marking liner edge onto wall board ENGLEFIELD Page 5...
Page 6
Carefully measure and mark pattern on wall 80~100 board surface as shown in figure 9. This pattern applies to: • Flat shower wall • Side contour shower wall • Flat bath wall Mark the pattern but do not apply adhesive Adhesive at this stage.
Page 7
Ensure the protective film has been peeled back from tiling bead of tray or bath before applying sealant. Leave the rest of the tray or IMPORTANT bath covered by the film to protect it during installation. ENGLEFIELD Page 7...
Need help?
Do you have a question about the Flat Shower Wall and is the answer not in the manual?
Questions and answers