Summary of Contents for Nauticam WIDE ANGLE CONVERSION PORT 2
Page 1
OREWORD Thank you for your purchase of a NAUTICAM product. At NAUTICAM, we pride ourselves in the ability to recognize the requirements of professional as well as amateur underwater photographers and fulfill them through the innovative designs of our products. We strive to achieve a...
THE HOUSING AND LENS PORT •••••••••••••••••6 territory where the service center is located. •••••••••••••••••••••• 6 RANSPORTING THE LENS NAUTICAM does not hold responsibility for damage, of any nature, to any equipment used with and/or placed within our •••••••••••••••••••••••••• 7 EMOVING products.
PECIFICATIONS Outer diameter x Length DIA267 mm x 220 mm Weight (air / uw) 7.25kg/0.45kg Body construction Hard-anodized aluminum alloy Lens construction 4 elements Lens coatings Inside anti-reflective coating Focal range 0~Infinity 140° (Ref. 14mm equivalent on Maximum FOV (UW) full-frame camera) Mount system N120...
• • A damaged O-ring should be discarded immediately and Defective products should be shipped to our distributors for replaced only with one that is provided by NAUTICAM. service, unauthorized disassembling and/or modifications • Replace the main O-ring annually. could result in malfunction or leakage.
ACKAGE ONTENTS DENTIFICATION OF ARTS • Wide Angle Conversion Port - 2 (WACP-2) • Hand Grip Hard Lens Cap Hard Lens Cap Rear Lens Cap • Rear Lens Cap Adjustable Lens Shade • 90140 Spare O-ring Alignment ‘O’ Index • Cleaning Cloth •...
REPARATION OF THE HOUSING AND LENS PORT RANSPORTING THE LENS After verifying that the main O-ring of the housing and lens port are in good condition, lightly coat it with the lubricant provided. Make sure the O-ring grooves located in the front part of the housing and rear part of the lens port are free from any foreign material;...
EMOVING Press the snap-on center-pinch to remove the lens Then, lift the front hard lens cap up. cap as shown. To cover the cap on WACP-2, reverse the above steps.
NSTALLING ON A HOUSING Make sure that the port locking lever of the housing is Align the ‘O’ index on the lens and the housing. Then, on the release position as shown. gently push the housing, until it cannot go in any further.
OUNTING WITH AN ADAPTOR EXTENSION RING Lock the port into place by turning the port locking lever Confirm that the adaptor / extension ring is unlocked. (Please refer to the corresponding manual for adaptor / to the inward position. To ensure that the port is extension ring installation.) securely mounted, confirm that the green line on the safety button of the port locking lever is visible.
DJUSTING HADE ANGLE Turn the adaptor/extension ring until the ‘O’ index on the Rotate the knob for shades 180º lens aligns with the ‘I’ index on the adaptor / extension counterclockwise as shown. ring. Ensure to fully open shades of WACP-2 to use wide angle To un-mount the lens from adaptor/extension ring, reverse the above steps.
To close the shades, re-rotate the knob for shades 180º clockwise as shown.
Page 12
Canon EF 16-35mm F4L IS USM 72°-128° Full 16-35 mm GF mount FUJINON GF 23mmF4 R LM WR 120° 23 mm N120 Fujifilm N120 Fujifilm N120 Fujifilm N120 Fujifilm Fujifilm GFX 50S/GFX 100 Please visit www.nauticam.com/ for the latest WACP-2 compatibility chart.