Advertisement
Hazardous or unsafe practice will possibly result
in personal injury or property damage.
• Do not repair or work on unit without chocking
lift in an upright position.
• Do not overload the lift (see nameplate for capac-
ity).
• Do not put feet or hands under lift when operat-
ing.
• Do not stand, sit or climb on the lift while sta-
tionary or moving.
• Do not move lift when load is in an elevated posi-
tion.
• Place load in the center and evenly distributed on
the table.
S E C T I O N 3
UNPACKING
AND ASSEMBLY
A.
INSPECTION:
Upon receipt of the XP24-3 and XP24-6 Scissor lift,
inspect the equipment completely to determine if there
is any shipment damage and that the lift is complete.
Do not use the lift if there appears to be any damage.
Figure 1: Foot Pedal
Page 8 —
PRESTO OWNER'S MANUAL: XP24-3 & XP24-6 SERIES
CAUTION!
CAUTION!
S E C T I O N 4
OPERATION
A. METHOD OF OPERATION:
• To raise turn release knob clockwise till fully closed.
Press on foot pedal to raise.
• To lower slowly turn release knob counter clockwise
till the desired rate of decent is achieved.
• To lock lift in position press down on the wheel
breaks located on the swivel casters at the push
handle end.
S E C T I O N 5
MAINTENANCE
Generally, the XP Series of scissor lifts require little
maintenance. However, routine inspection and main-
tenance will minimize costly repairs or hazardous
conditions.
WARNING!
Never go under or service lift with a load on the table
or with the scissor mechanism loaded. If possible,
service the lift in a down position.
A. ROUTINE INSPECTION
AND LOAD MAINTENANCE:
All routine inspection maintenance should be performed
on a monthly basis.
• Lubricate wheels and all pivot points of the unit
with a medium weight oil or light grease.
• Check wheels for wear and replace if necessary.
• Check for leaks by looking for tell tale oil spots on
the floor under the lift.
• Check oil level and fill if needed.
Recommended hydraulic oil: Super Hydraulic 32
Conoco
Advertisement
