Advertisement
INSTALL INSTRUCTIONS PT-A-920
TOOLS REQUIRED:
Drill and Drill bits
4.5" Hole saw
PARTS and HARDWARE:
QTY DESCRIPTION
1
Power Vent assembly
1
Rubber tube adaptor
1
4.250" od x 12" long Extension tube
1
6" X 6" vent grill
1
Under dash bracket for switch
1
Rocker switch
1
Power Vent Label
6
#10 x 1/2" PPHSMS
NOTES:
1. Silicone sealant, wiring, wire terminals, wire ties and fuse are not included.
These items must be provided by installer
2. Power vent package includes a bag with (5) #6 x 1" stainless steel flat head sheet metal
screws for attaching vent to roof.
3. Open packaging and confirm that you have all items on parts list.
Carefully take your time in measuring for accurate vent hole locations.
Be sure to run a power and ground wires to the approximate location of power vent so you can
access it through the 4.5" diameter hole in the roof.
Vacuum all metal chips after drilling and or cutting holes.
Read all instructions before installing any Havis, Inc. products.
Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with installation kit.
PRISONER TRANSPORT POWER VENT
Tape measure
Philips screwdriver
IMPORTANT
Always
Wire cutter/crimper
Caulk gun
PART#
23144
23178
23176
(Only used for Medium roof height van)
15662
14082
13994
11129
16436
!
Saw to cut plastic tube
File
(C-UDB-1)
(C-SW-1)
(C-LABEL-S)
PT-A-920_INST-8-20
Advertisement
Table of Contents
Summary of Contents for Havis PT-A-920
- Page 1 Vacuum all metal chips after drilling and or cutting holes. Always Read all instructions before installing any Havis, Inc. products. Check for obstructions (Wires, brake lines, fuel tank, etc.) before drilling any holes! Use hardware provided with installation kit.
- Page 2 PT-A-920 Assembly #6 x 1” Phillips flat head sheet metal screws Power vent assembly #23144 OEM Van roof Cut 4.5” diameter hole 4” long tube included with # 23144 power vent used for low roof van application. 12” long tube # 23176 provided for Drill ¼”...
- Page 3 PT-A-920 Installation Procedure 1. All wiring should be routed to approximate locations prior to installing sheet metal parts. 2. With PT insert bulkheads, benches and walls installed, measure from the top of the PT driver side wall to a location between the van roof ribs and cross supports. Vent does NOT mount in the center of the van because of overlapping ceiling sheet metal and center divider.
Need help?
Do you have a question about the PT-A-920 and is the answer not in the manual?
Questions and answers