Heatzilla SY-GH150 Manual

Heatzilla SY-GH150 Manual

Portable gas heater

Advertisement

Quick Links

MA N U A L
D E U S U A R I O
S Y · G H1 5 0
P O R T A B L E G A S H E A T E R

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SY-GH150 and is the answer not in the manual?

Questions and answers

Summary of Contents for Heatzilla SY-GH150

  • Page 1 MA N U A L D E U S U A R I O S Y · G H1 5 0 P O R T A B L E G A S H E A T E R...
  • Page 2: Environmental Recycling Policy

    Welcome Thank you for purchasing the HEATZILLA Mobile Gas Heater. This portable gas heater is designed to give safe, efficient and reliable operation, and is for use with LPG/Butane gas only. Gas bottles are not supplied with the unit, but are readily available from builders’...
  • Page 3: Important Safeguards

    • Do not use the appliance if any of its parts have been in contact with water or high humidity. Contact the technical department of Heatzilla. • ALWAYS position the gas heater observing the minimum safety distances from objects and walls at all times: 50 cm on its sides;...
  • Page 4 • Do not repair the appliance by yourself in case of any malfunction. Contact Heatzilla technical service department for a proper repair. • The volume of the room should be greater than or equal to 15 m . For the...
  • Page 5: Important Warning

    combustion products • The grid protection of this appliance is to prevent risks with fire or burns and should never be dismounted. IT DOES NOT PROTECT FULLY THE CHILDREN OR PERSONS WITH REDUCED PHISICAL OR MENTAL CAPABILITIES. • Follow carefully the installation instructions and in the case of gas smell: - Close the tap on the gas regulator - Open the windows - Do not operate any electrical switch or turn on a flame...
  • Page 6: Carbon Monoxide Warning

    VENTILATION DO NOT COVER Features of the SY-GH150 Gas Heater The SY-GH150 gas heater comprises three groups of components: GAS SUPPLY COMPONENTS The gas supply to the machine is by means of a high-pressure hose, connected to a gas cylinder, via a pressure regulator.
  • Page 7: Ignition Components

    IGNITION COMPONENTS An igniter is positioned beside the Pilot Light. When the ignition button is pressed, a spark is generated which ignites the gas. Heat from the flame is sensed by a thermocouple which is connected to the Flame Failure Valve. As the thermocouple heats up, a low voltage is fed to the Safety Cut-Off Valve, causing the valve to open, so that after a short period, the Control Valve (see ‘Lighting the Heater’...
  • Page 8 2. Fix the gas regulator to the gas hose, securing it with the screws hose clip supplied. 3. Place the filled gas bottle into the into the back of the heater with the valve outlet facing outwards. 4. Connect the gas regulator onto the outlet of the gas bottle using the integral clasp. 5.
  • Page 9 Material Clearance It is recommended that the heater must be positioned 50cm. clearance to the sides and rear. However, any household furnishing should be at a safe distance away as they could be adversely affected by the heat. Always position the heater facing the centre of the room and as shown in the diagram below. Never place any object on, or against the heater.
  • Page 10 Parts of the Gas Heater AERATION HOLES CONTROL PANEL FRONT PANEL REAR PANEL CERAMIC PANELS PROTECTIVE GRID PILOT FLAME WHEELS Ignition Instruction The gas heater can be regulated to three different heat intensities: 1-Low, 2-Medium, 3-High. The Ignition mode button is to generate the spark on the pilot burner. (piezo ignition) •...
  • Page 11 Note: The first ignition of a new gas heater, it may be necessary to keep the control knob button down for a longer time in order to purge air from the system. Once the heater is alight, turning the control knob to MEDIUM or HIGH will light the second and third panel automatically.
  • Page 12: Troubleshooting

    5. Regularly check the flexible tubing between the regulator and heater and replace if cracked. In the event of damage or broken components, replacements should only be obtained from Heatzilla service centre. Storage: 1. For long term storage, always disconnect the bottle and store the heater in a well- ventilated area away from combustible materials.
  • Page 13 If in the case you can smell gas, it can be due to gas leakage from the hose or the tube connection. Carry out a leak test to determine the source. Model identifier(s): SY-GH150 Indirect heating functionality: NO Direct heat output: 4.2KW...
  • Page 14: Specifications

    Supply pressure: 28-30 mbar Please note that the details and specifications contained herein are correct at the time of going to print. However, HEATZILLA reserve the right to change specifications at any time without prior notice. Always consult the heater’s data plate.
  • Page 15 Tel: 902 430 967 Fax: 91 8864285 NIF: B83254763 Manufacturing country: China Description: Portable Gas Heater Heatzilla® SY-MG150 complies with the following directives: We hereby declare that this product(s) complies with the following directive(s): 2016/426 Appliances Burning Gaseous Fuels. 2009/125/EC...

Table of Contents