komodo Colossus Quick Start Manual

This tent has been developed and is intended to provide shelter from sun and light rain. It is not intended for use during
heavy rain, wind, hail or snow.
The tent should be dismantled when not in use.
•
Do not use any gas or flame sources under, inside or near this product.
•
Under no circumstances should this product be used as a permanent or temporary storage facility.
•
This product meets the flammability requirements of CPAI-84. This product is not fire proof. The fabric may burn if left in
continuous contact with any flame source.
Never use devices that produce fumes, including stoves, lanterns, candles or heaters in or around this tent.
: Check products are all present-
Inner tent, outer tent, poles, tent pegs
and the guy ropes.
: Once threaded through the
sleeves, put the ends of the fibreglass
poles through into the plastic tubes.
: Check that the fibreglass poles
are firmly inserted into the plastic
tubes and that they are standing
steadily.
: Unroll the inner tent. Lay the
fibreglass poles out in order alongside
the sleeves on the outside of the tent.
: Raise the tent by bending the
fibreglass poles and placing their ends
over the corresponding pole pins.
: Check that the ends of the
steel poles are fitted securely over the
streel ring pins at each corner of the
tent.
: Slide the fibreglass poles into
the insert sleeves.
: Once the poles are all raised,
attach the tent clips to the fibreglass
poles.
: The steel poles will support the
opening flap section of the tent.