Advertisement
: Use the wire tent pegs to peg
the base of each pole to the ground.
Drive the pegs into the ground at a
45° angle.
: Tie the fibreglass poles to the
outer tent using the straps in the
center.
: Use the S hooks to secure the
fibreglass poles to the tent walls.
To disassemble the tent, simply reverse the steps.
If the tent has rainwater or morning dew on it, allow the cover to fully dry before packing up. If you are unable to allow
the tent to dry out while packing it up, unpack it and allow it to dry at the soonest possible time to avoid the growth of
mold or mildew.
: The assembled inner tent
should appear as shown above.
: Turn the outer tent the right
way up (with fibreglass poles on the
inside), and lay it over the inner tent.
: Secure all fibreglass poles
using the available S hooks.
: Insert the outer tent fibreglass
poles through the hooks on the tent
itself.
: Peg the outer tent to the
ground. Start with the rear corners,
then the front corners, then finally the
sides.
: The tent is now ready for use.
Advertisement
