Advertisement
HOW TO OPERATE
1. Cut the fruit in half.
2. Put a cup under the spout.
3. Plug in the socket. Switch to the position of "1". Align the center of cut orange with
the top of juicer head and put it down. Press handle to make juicer head rotate. Impose
even pressure until juice is flowing out (see Fig 2). Then take out the peel and change
another cut orange. Repeat above operation. Pay attention to clean pumice in the filter
to avoid overflow of pumice.
4. Switch to the position of "0" when stop using it. Pull out the plug.
Don't press too tight. If you hear the motor rotating slowly or it stops, you are pressing
too tight. The motor will not become damaged because the thermal protective device
turns the motor off if overstrained. If this occurs, we advise you to turn the juicer off with
the on/off switch. After a few minutes, the motor will cool off and the juicer can be used
again. Always switch the juicer off after use.
Advertisement
