Table of Contents
Advertisement
›
Using a screwdriver, Unlock the fuse
›
Remove the headlight in the direction of arrow
Replacing the light bulb
›
Press the latch on the connector in the direction of arrow
›
Remove the key in the direction of the arrow
›
Turn the socket with the bulb to the stop in the direction of the arrow
›
Remove the socket with the bulb in the direction of arrow
›
Insert the new bulb into the headlight and turn counter to the direction of
arrow
as far as the stop.
7
›
Fit the connector.
Refit the headlight and grille
›
Replace the fog light by inserting it in the opposite direction of the arrow
and tighten.
» fig.
114.
›
Insert the guard and push it gently until it locks into place.
Removing/installing taillights
Fig. 115 Removing the light/pulling out the connector
Read and observe
and
Removing
›
Open the boot lid.
›
Lift up the cover in the direction of arrow
›
Hold the light in one hand and remove the plastic nut
arrow
with the other.
2
›
Hold the light and carefully remove it by moving it side to side.
›
Pull the connector lock
in the direction of arrow
B
›
Press the catch mechanism
C
›
Remove the connector.
in the direction of arrow
C
.
4
» fig.
5
.
6
.
8
on page 97 first.
» fig.
115.
1
in the direction of
A
.
3
in the direction of arrow
.
4
.
Install
3
›
Insert the connector into the lamp and lock it securely.
›
Insert the light into the opening in the body.
›
Push in the light so that the light holder locks into the bolt on the outside of
114.
the opening in the body.
›
Tightly screw the light with the plastic nut
.
7
row
» fig.
115.
2
›
Fold the cover in the opposite direction to arrow
CAUTION
Ensure that the cable bundle does not become stuck between the body and
■
the lamp when it is being refitted – or there is a risk of damage to the electrical
installation and risk of water ingress.
4
If you are not sure whether the cable bundle has been pinched, we recom-
■
mend that you have the connection of the light checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing the bulbs in the tail lamp assembly
Read and observe
›
Unlock the bulb holder using the locking latches in the areas
page 101 marked with arrows and remove the bulb holder from the light.
›
Remove the faulty bulb
›
Insert a new bulb into the socket.
›
Turn the defective bulb
the holder.
›
Insert a new bulb
stop.
›
Insert the bulb holder in the light.
in the opposite direction to ar-
A
1
Fig. 116
Inner part of the light
and
on page 97 first.
» fig. 116
from the holder.
A
anticlockwise as far as it will go and remove from
B
into the holder and turn in a clockwise direction to the
B
Fuses and light bulbs
.
» fig. 115
on
101
Advertisement
Table of Contents
