Advertisement
Quick Links
Advertisement
Related Manuals for novasmart runR One
Summary of Contents for novasmart runR One
- Page 1 Smartband U S E R G U I D E runR One Fitness Tracker...
- Page 2 G E T T I N G S T A R T E D Read this user guide carefully before using the product. lt contains important information for your safety as well as use and maintenance advice. Keep this user guide for future reference. lf this product is passed to a third party, this user guide must be included.
- Page 3 ■ Charge bracelet with 5 V/ 100-2000 mA, do not use higher power supply voltage to prevent overload. ■ Do not leave the product in direct sunlight for an extended period of time. ■ Do not dispose the product in a fire. Built-in battery could explode.
- Page 4 ■ The product should usually rest a finger‘s width below the wrist bone, as you would normally wear a watch. ■ This product has been classified as IP67 and is protected against the effects of temporary im- mersion in water. For diving in larger depth, the product is NOT suitable.
- Page 5 Continued use, even after symptoms subside, may result in renewed or increased irritation. lf symp- toms persist, consult your doctor. Blood pressure notice ■ Blood pressure can be subjected to wide fluctua- tions in a short period of time as its level depends on many factors.
- Page 6 I N T E N D E D U S E This Smartband is intended for monitoring fitness- related metrics such as heart-rate, blood pressure, distance walked or run, calorie consumption and quality of sleep. Data measured should not be used for any medical, ambulatory or dietary reference.
- Page 7 4. Blood pressure and heart rate sensors 5. Build-in USB charging port 6. USB charging with built-in USB port C H A R G I N G ■ Identify the strap pointed to by a USB mark on the back of the product. Hold the product body with one hand and pull the strap with another hand at 45 degrees away from the product to reveal a built-in USB port.
- Page 8 ■ Upon charging, a battery charging icon will be displayed briefly followed by a short vibration. ■ Average charging time should take ca. 2 hours. T U R N I N G O N A N D O F F To turn on ■...
- Page 9 To turn off ■ Briefly press the function key to switch between the menu items. Go to “More”, long press the function key and switch to the turning off menu as shown. ■ Press and hold function key for 3 seconds. ■...
- Page 10 “ F U N D O P R O ” A P P For the best experience download and install the “FunDo Pro” app on the App Store, Google Play or by scanning the following QR code. Open the app and confi rm all permissions to access all features.
- Page 11 ■ Open “FunDo Pro” app. ■ Go to “More” > “+Add device” and from the list of device select “runR One” with the corresponding ID number to pair with. ■ The ID number can be found in the menu of the Smartband.
- Page 12 W A K I N G U P S C R E E N To preserve battery screen goes off when not in use. lt wakes up automatically when you turn your wrist towards you. To disable waking up feature or to set a specific time frame when it is disabled (e.g.
- Page 13 1. Time and date screen Once Smartband and smartphone are paired, the time and date is automatically synchronized. lf the synchronization fails, open “FunDo Pro” app and tap the icon in the top left corner to synchronize manually. Battery level Bluetooth connection Current date...
- Page 14 During exercise, tap on the function key once to wake up the screen and ■ Long press to pause training section ■ Tap again to resume training section ■ Long press the function key again to exit training section. T I P The heart rate measurements taken in sport mode are not synchronized with “FunDo...
- Page 15 The steps will not be counted if you do not swing your arms during walk or exercise. By default, distance walked or run is shown in kilometers. To change the unit to imperial “mile”, open “FunDo Pro” app and go to “More”> “Unit Settings” menu. Steps taken >...
- Page 16 4. Blood pressure monitor Measures your current blood pressure. One-time measurements To make a quick and one time measurement, simply go to “Health”, long press the function key, and select the blood pressure menu “BP” as shown by holding the function key for 3 seconds, rest your arm on a table so the Smartband is at about the same height as your heart and wait ca.
- Page 17 T I P It is important to measure the blood pressure at the same time each day such as morning and evening. 5. Heart rate monitor Measure your current heart rate. To start manual measurements, simply go to “Health”, long press the function key, and select the heart rate menu as shown by holding the function key for 3 seconds.
- Page 18 Regular heart rate measurements To turn on automatic heart rate monitoring 1. Open “FunDo Pro” app and go to “More” > “Heart rate test”, set start and end time for contin- uous heart rate monitoring. 2. Set monitoring frequency. 3. Toggle to enable “Heart rate test”. 4.
- Page 19 R E C E I V E S M A R T P H O N E N O T I F I C A T I O N S ■ If the Smartband is connected to the “FunDo Pro” app, make sure that the permissions for messages from the smartphone are enabled.
- Page 20 U S I N G S T O P W A T C H ■ Go to “More” on the Smartband, long press the function key and switch to the stopwatch menu as shown. ■ Press and hold function key for ca. 3 seconds to enter the stopwatch mode.
- Page 21 M U S I C C O N T R O L ■ Go to “More” on the Smartband, long press the function key and switch to the music menu as shown. ■ If your smartphone plays music, you can control the music.
- Page 22 D A S H B O A R D “Analysis”, the “FunDo Pro” icon in the center and “Report” allow you to view history of all measure- ments taken and data summaries.
- Page 23 A P P S E T T I N G S M E N U To access settings menu open “FunDo Pro” app and go to “More” menu: Tap to connect or disconnect the device. Activate or deactivate message notifications from various apps.
- Page 24 ■ Set an alarm Set alarm clock. ■ Raise hand/turn wrist detection Set screen waking up by turning your wrist. ■ Do not disturb mode Set the time for “Do not disturb”. ■ Firmware upgrade Upgrade the Smartband Firmware. ■ Unit settings Change the preferred unit for distance and temperature.
- Page 25 ■ Clean the charging plates/port, blood sensors and heart sensor regularly as accumulated dust and lint could affect charging process. ■ When not in use, store the product in its original packaging, out of reach of children and pets. T E C H N I C A L D A T A ■...
- Page 26 D I S P O S A L I N S T R U C T I O N S Used electrical and electronic products must not be discarded with household waste. The presence of the WEEE symbol on the product – or its packaging serves as a reminder of this.
- Page 27 Radio Equipment Directive (RED) (2014/53/EU) and other applicable Directives, hence CE mark has been attached to it: Produced in China for novasmart c/o 3e oem sports AG Flurweg 11 82402 Seeshaupt Germany © novasmart. All rights reserved.
- Page 28 www.novasmart.net...
Need help?
Do you have a question about the runR One and is the answer not in the manual?
Questions and answers