Advertisement
INS TA L L AT I O N
E S61
Electric Strikes
1.
For new installations, surface mount ES61 strike first, then install exit device maintaining a minimum of
3⁄16" clearance.
2.
Determine the horizontal centerline 'G' of the Pullman Latch on the exit device and transfer to frame
stop. (see Fig. 1)
3.
Determine the distance 'E' from the door face to the vertical centerline 'X'. (See Fig 1A.)
Measure from the push side of the door to determine the location of the vertical centerline 'X'.
4.
With the centerlines marked, now mark door jamb per template drawing and cut frame for
strike installation.
5.
Insure that strike insert is placed in the center-most position on the strike faceplate prior to installation.
This allows maximum adjustability when installation is complete (see Fig. 2).
6.
Connect wires from power source to terminal screws on strike (polarity is not observed).
7.
Using slotted holes in chassis, install exit device electric strike with two (2) SHCS 1⁄4 - 20 x 1", socket
head cap screws (provided).
8.
Adjust chassis and electric insert (if necessary), horizontally, until pullman latch engages when door is
closed. Finally, tighten screws.
Important: Before proceeding to Step 9, be sure exit device dead locks when door is closed.
9.
Mark, drill and tap for the locking screws provided, and install to secure final location with
two (2) SHCS 1⁄4 - 20 x 1", screws (provided.)
Note:
If further adjustment is needed later, to correct door or weatherstrip misalignments, horizontally move
insert on its furrows by loosening screws under the face plate, and re-tighten when in the corrected
position (Fig. 2.).
Important:
The ES61 Electric Strike shall not be used as a door stop. Please install stops on frame in appropriate
locations. Ensure the exit device functions as intended for life safety concerns by verifying electric strike
and exit device compatibility. Maximum latch projection is essential to obtain full holding force.
ISES61
08281160
USA: DORMA DRIVE, DRAWER AC, REAMSTOWN, PA 17567 PHONE: (800) 523-8483 (717) 336-3881 FAX: (717) 336-2106
© 2011 DORMA
Email: archdw@dorma-usa.com Website: dorma-usa.com
PCN110055
R10/11SH
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dorma ES61
Summary of Contents for Dorma ES61
- Page 1 (Fig. 2.). Important: The ES61 Electric Strike shall not be used as a door stop. Please install stops on frame in appropriate locations. Ensure the exit device functions as intended for life safety concerns by verifying electric strike and exit device compatibility. Maximum latch projection is essential to obtain full holding force.
- Page 2 Original preparation is manufacturers not disturbed. (Fig.2). Fig.1 NOTE: Do Not scale specIfIcatIoNs subject to chaNge wIthout NotIce. © 2011 DORMA USA: DORMA DRIVE, DRAWER AC, REAMSTOWN, PA 17567 PHONE: (800) 523-8483 (717) 336-3881 FAX: (717) 336-2106 Email: archdw@dorma-usa.com Website: dorma-usa.com...
Need help?
Do you have a question about the ES61 and is the answer not in the manual?
Questions and answers