Advertisement
IMPORTANT–
Please Read and Follow!
•
Before beginning, please read these instructions completely and carefully.
•
Use caution during assembly to minimize scratches.
•
Do not remove permanently affixed labels, warnings or plates from the product. This may
void the warranty.
•
Please refer to the DFSB5 or DFBB5 Installation Instructions for more information on
installing the door panel.
•
The installer should leave instructions with the customer who should retain for local
inspector's use and future reference.
Installation with Wooden Full Overlay
Custom Door Front
Parts Included
Part
Quantity
Designer Handles
(2)
#10 x 3/4" Hex Head Screws
(8)
Installation Instructions
Required Tools
Electric Drill
3/16" (0.5 cm) Drill Bit
7/16" (1.1 cm) Spade or Forstner Bit (Counterbore)
Tape Measure
Hex Head Screw Driver
Masking Tape and Pencil
To Install:
1. Locate the wooden custom panel.
2. Using the illustrations on the next page, layout the handle location on the panels. It is
recommended that masking tape be placed where the four holes will be drilled to help mark
the hole placement and to prevent any damage to the door when drilling the holes.
3. Each Designer handle will be mounted using (4) of the #10 x 3/4" Hex head screws
provided. Using the 3/16"(0.5 cm) drill bit, drill completely through the door in the hole
locations. Using the 7/16" (1.1 cm) bit, counter-bore four holes 1/2" (1.2 cm) max. deep on
the BACKSIDE of the custom door panel.
4. Attach the Designer handle to the panel using (4) #10 x 3/4" screws provided.
5. Repeat steps 1 - 4 to attach other handle.
2
Handle Installation
13-1/8"
(33.3 cm)
A
1-1/2"
(3.8 cm)
13/16"
(2.1 cm)
A
32-19/32"
38-19/32"
(98.0 cm)
13/16"
(2.1 cm)
Custom Door
DFSB5 Side-by-Side (Front View)
Designer Handle
13/16"
Section A-A
(2.1 cm)
3/4" (1.9 cm)
Full Overlay
Panel
Specifications subject to change without notice.
3
9-21/32"
(24.5 cm)
1-1/2"
(3.8 cm)
13/16"
(2.1 cm)
(82.8 cm)
A
C L
A
13/16"
(2.1 cm)
2"
(5.1 cm)
32-19/32"
(82.8 cm)
Custom Door
DFBB5 Bottom Mount (Front View)
Designer Handle
7/16" (1.1 cm)
Counter Bore x 1/2"
Depth (max)
3/16" (0.5 cm)
Thru Hole
Advertisement
