Whirlpool CA10WXP0 Use And Care Manual page 9

Whirlpool air conditioner use & care guide
Table of Contents

Advertisement

Available languages

Available languages

Timer delay
To set the Timer for a 1- to 24-hour delay until the air
conditioner turns off (the air conditioner must be On):
1. Press TIMER. Indicator light will flash.
2. Press the plus or minus button to adjust the delay time (1 to
24 hours).
3. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off air conditioner.
2. Press TIMER. Indicator light will flash.
3. Press the plus or minus button to change delay time (1 to
24 hours).
4. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To set the Timer to turn on the air conditioner, changing
the previous settings:
1. Turn air conditioner on.
2. Adjust MODE to Auto, Cool, Fan Only, or Power Saver.
3. Adjust FAN SPEED to Turbo, High or Low.
4. Adjust temperature between 64°F (18ºC) and 86°F (30ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Indicator light will flash.
7. Press the plus or minus button to change delay time (1 to
24 hours).
8. Press TIMER again or wait 10 seconds. Indicator light will
remain on.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Indicator light will shut off.
To see the remaining time (in hours):
1. Press TIMER once after it has been programmed.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.
To operate air conditioner with remote control
Auto Cool
Cool
Fan Only
Power Saver
Timer
NOTE: Two AA batteries (not included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To turn the air conditioner on or off:
Press POWER ON/OFF.
To select the mode:
Press AUTO COOL, COOL, FAN ONLY, or POWER SAVER.
Auto Cool - fan speed is adjusted automatically.
Fan Only - fan speed is automatically set at Turbo.
Cool or Power Saver - you can adjust the fan speed.
Power Saver
POWER
ON/OFF
Turbo
High
FAN
SPEED
Low
Temp / Time
POWER
ON/OFF
Auto Cool
Cool
Fan Only
9

Advertisement

Table of Contents
loading

Table of Contents