Commissioning And Maintenance; Releasing The Transducer; Instruments Admissions; Dimensional Drawing - OHIO SEMITRONICS DVT Series Operating Instructions Manual

6. Commissioning and maintenance

Switch on the power supply and the measuring input.
No maintenance is required.

7. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 7.
Fig. 7
8. Agency approvals
CSA approved for USA and Canada
file-nr. 204767
7004-00062-A Rev --.indd

9. Dimensional drawing

Fig. 8. Housing type P8/35 onto a top hat rail (35 ×15 mm or
35×7.5 mm) acc. to EN 50 022.
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
both part 15 of the FCC Rules and the radio interference
regulations of the Canadian Department of Communi-
cations: These limits are designed to provide reasona-
ble protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accor-
dance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is like to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
Page 10 of 12
112.5
114.1
5 6 7 8
1 2 3 4
35
8/12/09