Subscribe to Our Youtube Channel
Summary of Contents for Digga HALO
- Page 1 Field Test Unit - 2019 OPERATORS MANUAL PM-000198 JULY 2019 DIGGA HALO OPERATORS MANUAL - PM-000198...
-
Page 2: Main Function
When the drive is hanging free when the machine is not operational, the LED sequence may appear to be incorrect or ‘backwards’ when tilting the drive about the hitch. It’s not until the drill pivots about the end of the auger/pile that the Halo system will make sense to the operator. - Page 3 LED zero mode sequence for an indication of zero mode. Tap the switch firmly to activate zero mode and the Halo LED lights will all flash blue for a moment. When in zero mode, the middle section of the LED array will be blue also.
-
Page 4: Components List
COMPONENTS LIST REF HALO ITEM HOOD FITTED WITH HALO LIGHT RING POWER CABLE TO BATTERY BATTERY WITH ZERO SWITCH CHARGER HALO HOOD BOX PM-000198 - DIGGA HALO OPERATORS MANUAL JULY 2019... -
Page 5: Spare Batteries
Through normal use, approx. 8-9 hours. Spare batteries and charges are available for purchase. Leaving the Halo turned on whilst display ‘all green’ will use the battery at a slightly faster rate. Once the power has been depleted, the LEDs will turn off and the battery will need to be recharged. -
Page 6: Troubleshooting
This can be dealt with by zeroing the Halo prior to each use where precision is required, or the Halo can be recalibrated by Digga (details of this procedure including cost are to be advised at a later date). - Page 7 Halo system. If the readings are not useful in such applications, either the operator can bring the drive to a halt to take a valid reading from the Halo at rest, or disconnect the Halo whilst that ground is making it difficult to produce a useful reading.
- Page 8 JULY 2019 DIGGA HALO OPERATORS MANUAL - PM-000198 PM-000198 - DIGGA HALO OPERATORS MANUAL JULY 2019...
Need help?
Do you have a question about the HALO and is the answer not in the manual?
Questions and answers