Advertisement
(See list at end of instructions)
(See list at end of instructions)
(See list at end of instructions)
© Jack Sealey limited
4.5.
4.5.1.
4.5.2.
4.5.3.
4.5.4.
4.5.5.
Filter Replace
4.6.
4.6.1.
4.6.2.
4.6.3.
4.6.4.
4.6.5.
4.6.6.
Additive Reset
4.7.
4.7.1.
4.7.2.
4.7.3.
4.7.4.
4.7.5.
4.7.6.
4.7.7.
Regenerate Filter
Original Language Version
Filter Replace
Press the Function button to select the appropriate system. (There is a
full list of systems on the rear of the tool).
Press mode button to select correct type (Filter Replace).
Press the 'oK' button to perform the function.
once the function has completed, the Mode LED will flash to indicate a
successful reset.
If the function is unsuccessful, the 3 System Selection LEDs will flash.
additive Reset
Press the Function button to select the appropriate system. (There is a full
list of systems on the rear of the tool).
Press mode button to select correct type (Additive Reset).
Press the 'oK' button to perform the function.
once the function has completed, the Mode LED will flash to indicate a
successful reset.
If the function is unsuccessful, the 3 System Selection LEDs will flash.
disconnect tester, open filler cap for more than 5 seconds, then close `
again.
Regenerate Filter
Start the vehicle's engine and allow it to warm up.
Press the Function button to select the appropriate system. (There is a full
list of systems on the rear of the tool).
Press mode button to select correct type (Regenerate Filter).
Press the 'oK' button to perform the function.
once the function has completed, the Mode LED will flash to indicate a
successful reset.
If the function is unsuccessful, the 3 System Selection LEDs will flash.
Switch the ignition off, unplug the tool and turn ignition on.
note: Regeneration takes around 15 mins in total (2 mins running at idle,
8 mins at 4000rpm and then 5 mins at idle). Ensure that rear / exhaust area
of the vehicle is kept clear of people for this period.
VS8626 Issue 3 (H5F) 04/04/18
Advertisement
