Table of Contents
Advertisement
3. Installing the Quick-Lock Mini
3.1. Positioning the Quick-Lock sleeve on the packer
Set packer to nominal width
• Set the adjustable chassis of the packer to
the nominal width of the host pipe. (See
also instructions "Offset packer with
adjustable chassis" 3.4, Appendix 4 of the
Quick-Lock Manual).
Positioning the sleeve on the packer
• Position the Quick-Lock sleeve flush on
the packer.
• Turn the Quick-Lock sleeve so that the
middle of the toothed strip is in the
12 o'clock position.
• Depending on which way you are looking,
the lock is in the 11 o'clock or the 1 o'clock
position.
• After installation, the lock is always at the
top, i.e in the 12 o'clock position.
To install the Quick-Lock Mini bendable sleeves
(90 mm), use our bendable Quick-Lock packer
in conjunction with the appropriate push rods
and sliding camera.
position: 11 o'clock position: 1 o'clock
8
Advertisement
Table of Contents
