The Drawer Regulation; Disassembling The Drawer; Installation And Regulation Of Metal Bar - Unihopper MAGICBOX H80 Installation Instruction

Drawer installation
：
Click

Disassembling the drawer:

The diameter of screwdriver bar: 6mm
Installation and regulation
of metal
bar
③
Click
③
1.The runner isn't stable when sliding?
2.The runner isn't sliding well? Please check if cutting size of the bottom and back panel is correct; and check if the bottom and cabinet are in the right position; check if both of the runners are in the
same level of front and back,left and right.
3.The drawer shakes? Check if the drawer side is installed correctly. if both of the runners are not paralleled, we have to regulate by the oval holes.
4.The drawer can't be closed well or the distance of soft-closing is too short?
5.The drawer is broken during the transportation?

The drawer regulation :

1
The diameter of screwdriver bar: 6mm
Steps of disassembling:
2
1. Press the handle.
2. Pull out the drawer
and finish.
Regulate
①
②
(1)
Please check is it any bits of wood or sundries on the runner when assembling it .
Please check if the drawer side is installed correctly, and check if the distance of the runner to cabinet side edge is correct.
During the transportation, please don't put the assembled drawer and cabinet upside down, otherwise it will make the drawer broken.
1
Disassembling metal bar
④
②
③
①
(2)
①
The diameter of screwdriver bar: 6mm
2
⑤
⑥
A type
fixed height
②
B type
③
with any height
①
②
Click
②
①