Advertisement
Table of Contents
Installation Instruction
Temporary Work Light
150 W LED Temporary High Bay
Read the installation instructions and all product labels before proceeding with the installation. This product must
be installed in full accordance with applicable electrical and building codes.
TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF FROM THE ELECTRICAL PANEL BEFORE INSTALLATION
OR MAINTENANCE.
SAFETY WARNINGS
• T o reduce the risk of fire and electrical shock, do not exceed the maximum wattage, including any additional
string loads.
• Suitable for use in damp locations.
• Do not submerse.
• Four units maximum can be daisy chained.
• Do not connect or disconnect when wet.
• Do not open – no user serviceable inside.
• This device is not intended for use with emergency exit fixtures or emergency exit lights.
• Operating Temperature: -30°C / -22°F to 40°C / 104°F
• 5 year limited warranty.
PRODUCT SPECIFICATIONS
Voltage
Wattage
Light Output
Power cord length
Wire
CRI
Amperage
IP Rating
120 V
150 W
15 000 lm
20 ft (6.1 m)
18 AWG
80
1.3 A
IP54
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Standard 67046
Summary of Contents for Standard 67046
- Page 1 Installation Instruction Temporary Work Light 150 W LED Temporary High Bay Read the installation instructions and all product labels before proceeding with the installation. This product must be installed in full accordance with applicable electrical and building codes. TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF FROM THE ELECTRICAL PANEL BEFORE INSTALLATION OR MAINTENANCE.
- Page 2 Installation Instruction Temporary Work Light 150 W LED Temporary High Bay INSTALLATION - STEPS 1. Turn OFF the power before proceeding with the installation. 2. H ang the luminaire where desired, using the designated hook on the handle. Ensure that it can handle a weight of 66 lbs.
Need help?
Do you have a question about the 67046 and is the answer not in the manual?
Questions and answers