RV Intelligence JAS30 Manual

Congratulations on your purchase of a Smart RV JAS30 Remote
Control! We believe this is going to make set up and tear down
of your RV simpler, easier, and more convenient by putting the
power literally into the palm of your hand!
B
EFORE YOU BEGIN THE INSTALLATION PROCESS
S
KILLS NEEDED
Please take the time to read these directions, if you are not
knowledgeable in working with low voltage (12 Vdc), high
current (30 Amp), electrical circuits, please allow a
professional to install our product so that you can
enjoy it safely.
T
OOLS NEEDED
 Screw drivers to remove the switch access plate/wall mount switch.
 Large crimping pliers to successfully compress the 10 AWG power tap connectors.
 Wire stripping and cutting tool that can strip 10 AWG wires.
 Voltage meter/resistance meter to test connections of the power wires.
W
ARNINGS AND CAUTIONS
 All electrical circuits are potentially dangerous. Incorrect installation could result in fire, injury or death. Only those who
are proficient in the installation of electrical equipment should install the Smart RV JAS30 Remote Control. The manufac-
turer specifically excludes any claims resulting from incorrect installation.
 Treat all electrical circuits as active, do not install in wet or rainy conditions.
 Turn off any circuits at the fuse or circuit breaker before attempting installation.
I
NSTALLATION
1. Write down the four-digit number on the bottom of your new Smart RV JAS30 Remote Control.
2. Locate the slide control switch in your RV.
2. Remove the switch plate, or open the panel, carefully extracting the wiring behind the switch.
3. There may be as many as five or even six wires on the back of the switch socket connected with four wire nuts. There is
one 12 Vdc, two motor connections from your slide control motor, and one or two ground wires.
4. Using the voltage meter, determine which of the wires are supplying power. Mark this wire using the "12 Vdc 30A Max"
label that is provided.
5. Using the resistance meter, identify which wire/s show zero resistance. Some RVs have multiple Ground wires, others do
not. Mark ONE of these wires with the provided "Ground" label.
6. The remaining two wires will connect your RV's switch to the slide control motor wires using wire nuts. On the side of the
wire nut closest to the switch, mark each of these wires with the provided "Switch" labels. On the other side of each wire
nut, mark each with the provided "Motor" and "Motor" label.
7. Before continuing, remove the fuse or turn off the breaker powering the unit you are modifying.
8. Loosen the wire nuts connecting the switch and motor wires. Use the wire stripping tool to trim the end of all four wires,
and strip 3/8 inch of the insulation to ensure the wires are straight and uniform.
9. The Smart RV JAS30 Remote Control is pre-labeled to match the labels attached as previously directed. Connect the Smart
RV JAS30 Remote Control as follows:
9.1 Match the solid black wire labeled "Ground" from the Smart RV JAS30 Remote Control with the wire you identified
and marked "Ground" coming from your RV. Place the two wires into the supplied 10 AWG tap connector and use
your crimping tool to completely close the connector onto the wires.
9.2 Match the solid red wire labeled "Power 12 Vdc 30A Max" from the Smart RV JAS30 Remote Control with the wire
you identified and marked "Power 12 Vdc 30A Max" coming from your RV. Place the two wires into the supplied 10
AWG tap connector and use your crimping tool to completely close the connector onto the wires.
The diagram above shows the general wiring configuration
of the slide unit in your RV prior to installing the
Smart RV JAS30 Remote Control.