Advertisement
Installation manual
Room separator LIGHT
The room separator LIGHT is made of lightweight polypropylene twin wall sheets and consists of two parts:
a wall panel and a foot-stand. Due to the smart design, the room separator will be set up in only a few
steps – easy, fast and without the use of tools. With special bayonet locks the wall panels can also be
connected to each other in no time.
Step 1: Set-up and positioning of the food-stand
1.1 Flap both sides of the foot-stand
upwards.
Step 2: Set-up of room separator
2.1 Put the wall panel from above
into the foot-stand.
Söhner Kunststofftechnik GmbH
Industriestraße 29
T +49 7138 812-200
D-74193 Schwaigern
F +49 7138 812-520
1.2 Fasten the sides using the
support elements. The support
elements need to be plugged
into the base panel.
2.2 Push the wall panel completely
down the food-stand till it
reaches the floor.
info@soehner.de
www.soehner.de
1.3 Place and position the foot-
stand. The stand can also be
fixed to the floor using hook
and loop fastener.
2.3 The room separator is set up.
Seite 1 / 2
Version 01
04/2020
Advertisement
Table of Contents
Summary of Contents for SOHNER LIGHT
- Page 1 Room separator LIGHT The room separator LIGHT is made of lightweight polypropylene twin wall sheets and consists of two parts: a wall panel and a foot-stand. Due to the smart design, the room separator will be set up in only a few steps –...
- Page 2 3). With the room separator LIGHT we facilitate the installation of temporary spaces, such as cabins or corridors, and the screening off individual areas. Stay healthy. If you have questions regarding the installation of the room separators or if you need further wall panels or foot-stands, please do not hesitate –...
Need help?
Do you have a question about the LIGHT and is the answer not in the manual?
Questions and answers