ROADGEAR RGABM1 User Manual & Fitting Instructions

ROADGEAR BOOT/CARGO MAT
Fitting & Care Instructions:
Your new Roadgear Boot Mat has been designed to fit and protect your vehicles boot or
cargo floor area. Please follow these instructions to ensure maximum life of the product
and the best fit is achieved with the maximum floor area covered:-
1. Firstly, clear the space where your Boot Mat is to be placed of any loose
obstacles.
2. Ensure the floor space is clean by wiping or vacuuming
3. Remove the Boot Mat from the packaging and unroll orientating the surface
pattern side up
4. Place the Boot Mat in the centre of the boot/cargo area and position to
achieve the maximum floor coverage
5. Your Boot Mat includes many trim lines incorporated in the surface design.
Take a marking pen and trace around the lines to be cut to remove any excess
or overhanging edges of the mat to create a custom fit
6. Test the fit once more to check the traced lines and make any corrections –
remember, it's better to remove less the first time
7. Using a sharp pair of scissors, take care and cut around the marked trim lines
to remove the excess edges
8. Re-test the fit and make any necessary additional mark lines and cuts to
ensure a snug fit
9. Repeat this process until the desired fit is achieved
•
Remove Boot Mat from packaging and face
pattern side up in centre of cargo/boot area
(PART No. RGABM1)
•
After marking which trim lines to
follow, cut carefully with sharp scissors
•
Re-test the fit and make any necessary
additional mark lines and cuts to ensure
a snug fit
•
Repeat steps 6, 7 & 8 as above until
the desired fit is achieved
•
Follow care and maintenance
instructions