Advertisement
Quick Links
- Preparation and Tools Required:
• T-5 Torx bit Driver
(may be supplied
with product)
- Removal of original band:
1.
With the T-5 Torx driver remove all 4
screws from the backside of the FitBit
Surge that attach the band to the display
unit.
NOTE: The screws must be saved to
attach the band adapter (be careful and
work over the pan with edges to prevent
loss of screws)
Place 4 screws in a safe area for re-use in
later steps.
2.
Score the sides of the band (not top or
bottom) with a sharp knife (just cutting
the band) to make it easier to pry off.
Instructions for FitBit® Surge Band
replacement and installation of band adapter
• P an with edge (to keep
screws from getting lost during
disassembly/reassembly)
• Knife (for scoring)
(continued)
Advertisement
Summary of Contents for Pentogon FitBit Surge Band
- Page 1 Instructions for FitBit® Surge Band replacement and installation of band adapter - Preparation and Tools Required: • P an with edge (to keep • T-5 Torx bit Driver • Knife (for scoring) screws from getting lost during (may be supplied disassembly/reassembly) with product) - Removal of original band:...
- Page 2 Instructions for FitBit® Surge Band replacement and installation of band adapter (cont.) 3. U sing a smooth flat metal object (butter knife, Cuticle pusher, etc) peel away the band from the display assembly. Warning: Be very careful removing the band on the front sides of the display, since the Bluetooh and GPS components are in this area (see illustrations).
- Page 3 Instructions for FitBit® Surge Band replacement and installation of band adapter (cont.) Start two of the four screws removed in Step 1, in the Large end adapter, taking care not to drive the screws all the way into the adapter just yet. Place the Large end adapter (with screws set in from Step-6) over the large end of the adapter, and now drive the screws...