NorComp 180-701-170-000 Instruction Sheet

PROPER USE GUIDELINES
Cumulative Trauma Disorder can result from the prolonged use of manually powered hand tools. NorComp hand
tools are intended for the occasional use and low volume applications.
RED BLUE
HAND TOOL
180-701-170-000
1. INTRODUCTION
NorComp 180-701-170-000 Hand Tool Assembly
consists of Die Assembly and Hand Tool Frame.
CAUTION Read these instructions thoroughly
before crimping any contacts.
NorComp, Inc.
Charlotte, NC
180-701-170-000
CONTACT
SIZE RANGE
(AWG)
28-24
This document is subject to change
Rev 8
WIRE
INSULATION DIAMETER
Max in. [mm]
0.040 [1.02]
Figure 1
2. DESCRIPTION
The tool features a tool frame with a stationary jaw
and handle, moving jaw, and moving handle. The
tool frame holds a die assembly with two crimping
chambers.
The die assembly features a wire anvil, insulation
anvil, wire crimper, and insulation crimper.
NOTE: Use 24-28 crimp section only for contacts:
180-001-170L001 / 180-101-170L001
180-002-170L001 / 180-102-170L001
11/15/2019
Instruction Sheet
IS-180S
STRIP LENGTH
in. [mm]
0.100 [2.54]
Page 1 of 3
Date Printed 11/15/2019