Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Meterk S1M-GW20-115
- Page 1 Translation of the original instructions ANGLE GRINDER S1M-GW20-115...
-
Page 4: Proper Usage
1. Proper usage WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fi e and/ The machine is intended for cutting, roughing, or serious injury. and brushing metal and stone materials without using water. - Page 5 the power tool. Keep cord away from f) Dress properly. Do not wear loose clothing heat, oil, sharp edges and moving parts. or jewellery. Keep your hair, clothing and gloves away from moving parts. Damaged or entangled cords increase the risk of electric shock.
-
Page 6: Special Safety Instructions
f) Keep cutting tools sharp and clean. Properly • The outside diameter and the thickness of maintained cutting tools with sharp cutting edges your accessory must be within the capacity rating of your power tool. Incorrectly sized are less likely to bind and are easier to control. accessories cannot be adequately guarded g) Use the power tool, accessories and tool or controlled. - Page 7 • Hold the power tool only by the insulated or pinched by the workpiece, the edge of the gripping surfaces when performing an wheel that is entering into the pinch point operation where the cutting accessory may can dig into the surface of the material causing contact hidden wiring or its own cord.
- Page 8 for your power tool and the specific guard • When wheel is binding or when interrupting designed for the selected wheel. Wheels for a cut for any reason, switch off the power tool and hold the power tool motionless until which the power tool was not designed cannot the wheel comes to a complete stop.
-
Page 9: Description Of Symbols
5. Description of symbols uncontrolled restarting. • When working stone, use dust extraction. Pay attention to all the signs and symbols shown The vacuum cleaner must be approved for in these instructions and on your tool. the extraction of stone dust. Using this Make a note of these signs and symbols. -
Page 10: Before Starting The Equipment
6. Layout least 1 minute with the grinding or cutting wheel fit ed in place. Vibrating wheels are to be replaced 1. Spindle lock immediately. 2. ON/OFF switch 3. Additional handle 8. Operation 4. Protective cover for grinding 5. Flange nut wrench 8.1 SWITCH (Fig. -
Page 11: Cleaning And Maintenance
9. Replacing the power cable a) Clamping flang b) Flange nut If the power cable for this equipment is damaged, • Flange arrangement when using a it must be replaced by the manufacturer or its depressedcentre cutting wheel (Fig. 8) aftersales service or similarly trained personnel to a) Clamping flang avoid danger. -
Page 12: Environmental Protection
laced by anyone but a qualified ele trician. 11.3 Maintenance There are no parts inside the equipment which require additional maintenance. 12. Repairs Only use accessories and spare parts recommended by the manufacturer. If the equipment should fail some day in spite of our quality controls and your maintenance, only have it repaired by an authorized electrician.
Need help?
Do you have a question about the S1M-GW20-115 and is the answer not in the manual?
Questions and answers
what attachment do I need to sharpen lawn mower blades
To sharpen lawn mower blades with the Meterk S1M-GW20-115 angle grinder, you need a grinding wheel that is recommended for the tool and the appropriate guard designed for that wheel. Use only compatible wheel types and ensure the guard is properly adjusted for safety.
This answer is automatically generated