Centenary Hire Smarttek INF-06360 Quick Start Manual

Smarttek Hot Water System
Model: INF-06360
Certified to Australian Standards AS2658: Portable Gas Hot Water
System (SAI Global : SAI-400040)
SAFETY INSTRUCTIONS
CARBON MONOXIDE HAZARD
USE IN WELL-VENTILATED AREAS
USING THIS APPLIANCE IN AN
INCLOSED SPACE WILL CASUE
DEATH.
DO NOT USE IN CARAVANS, TENTS, MARINE CRAFT,
CARS, MOBILE HOMES OR SIMILAR LOCATIONS.
This appliance must only be used in an above
ground, open air situation with natural ventilation
and without stagnant areas, where gas leakage
and products of combustion are rapidly dispersed
by wind and natural convection.
WARNING! Do use this appliance if it is leaking,
damaged or does not operate properly.
WARNING! Do not install this appliance near
flammable or volatile substances.
WARNING! This appliance is not intended for
the supply of drinking water.
WARNING! Check and confirm safe water
temperature before using this appliance. Water
from this appliance may be very hot.
CAUTION! Accessible parts of this appliance
may be very hot. Keep young children away.
CAUTION! This appliance must be protected
from the rain.
SET UP INSTRUCTIONS
WATER
> Connect the cold water supply hose to the Water
Inlet Valve.
> After connecting, turn the shower head ON/OFF
switch to the ON position.
> Fully open the cold water supply to confirm the
flow of cold water and to check for leaks and
correct leaks as necessary.
GAS
This appliance shall only be used with a refillable
propane LPG cylinder certified to AS2030.1 and the
supplied certified LPG hose and regulator
assembly.
NOTE: Gas cylinder must not exceed 9kg size.
Supplied by Centenary Hire. Ph: (07) 3715 9700
WARNING! It may be hazardous to attempt to fit
other types of gas containers.
> Connect the supplied Gas Inlet Adaptor to the
Gas Hot Water System Gas Inlet Valve.
> Check that seals between the appliance and the
gas container are in place and in good condition
before connecting the gas container. Do not use
this appliance if it has damaged or worn seals.
> Connect the supplied approved 1.5m LPG Gas
Hose with regulator assembly to the Hot Water
System Gas Inlet. Then connect the regulated end
to a 9kg LPG cylinder ensuring that there is no
strain on the cylinder or connections.
> Position the cylinder 1m away from the hot water
system.
CAUTION! Avoid kinking and twisting the gas
hose.
> After the gas inlet is connected, open the gas
supply valve and check for gas leak at all
connections using soapy water or testing solution.
Brush either solution onto the connection points
and look closely for bubbles indicating escaping
gas. If leaks are detected, shut off main gas supply
valve and securely re-tighten connections and then
repeat leak test.
WARNING! Never use a match of flame for leak
detection or in close proximity to the Hot Water
System and/or Gas supply.
> If there is a leak on the appliance (or smell of
gas), immediately turn off the cylinder valve,
remove the appliance to a well-ventilated location
away from any ignition source. Check for leaks
suing soapy water or testing solution.
> To check if the gas cylinder is empty, disconnect
the cylinder from the appliance and shake from
side to side. If there is no sound or movement of
liquid, the cylinder is empty.
OPERATIONAL INSTRUCTIONS
WARNING! Flue must not be blocked or
obstructed and clear from adjacent surfaces.
> Move the ON/OFF switch on the shower head to
the ON position. This will allow water to flow freely
through the hot water system once the water is
turned on.