Bear chair BC201 Instructions
  1. Manuals
  2. Brands
  3. Bear chair Manuals
  4. Indoor Furnishing
  5. BC201
  6. Instructions

Bear chair BC201 Instructions

Kit
Hide thumbs
1
2
3
4
5
Table of Contents

Advertisement

Quick Links

Download this manual
INSTRUCTIONS KIT BEAR CHAIR BC201

Parts list:

NR. parts
1.
Legs
2.
Seat slats
3.
Arm support
4.
Triangles
5.
Arms
6.
Additional Arm Support
7.
Struts
8.
Sides , left (L) en right (R)
9.
Bottom Back Support
10.
Back Slats
11.
Top Back Support
12.
Frontm Slat
13.
Comfort Slat
14.
Plated Screws
14.
Brass Plaque
1.
1.
4.
4.
4.
7.
6.
Note:
Put any loose parts ordered on the ground and check the numbers! Shed there, where necessary,
rough parts are smooth. Check before you glued, or glueing the right parts.
Read the installation requirements before you begin. Good luck with the installation!
3.
3.
5.
5.
2.
Bear chair Nederland
Quanty
2
6
2
2
2
2
2
2
1
7
1
1
1
68
1
10.
8.
8.
Postbus 500
3700 AM Zeist
Original Bear Chair BC201
9.
11.
12.
13.
14.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the BC201 and is the answer not in the manual?

Questions and answers

Summary of Contents for Bear chair BC201

  • Page 1 INSTRUCTIONS KIT BEAR CHAIR BC201 Parts list: NR. parts Quanty Legs Original Bear Chair BC201 Seat slats Arm support Triangles Arms Additional Arm Support Struts Sides , left (L) en right (R) Bottom Back Support Back Slats Top Back Support...
  • Page 2 step Set the bottom back support (9) and top back support (11) on a flat surface with the curved sides and countersunk holes facing up. Arrange the seven back slats (10) with the longest in the centre, on the supports. step Push al the slats together so that there is even spacing on each side.
  • Page 3 step Place the comfort slat (13) and six seat slats(2) on the sides as shown in the picture, and space out evenly, leaving a small gap between the comfort slat and the back assembly. step Attach each arm support(3) to the tops of the legs with two screws.
  • Page 4 Knock the caps under the legs and fit the brass plate on the front of the chair. step Remove any adhesive from the chair and sanding rough parts smooth. Your seat is ready for use. Enjoy your Bear chair...
  • Page 5 ALWAYS CHECK THE LOOSE PARTS : You have purchased a kit of the BC201 . This kit box packed with care . If, after the checking nevertheless appear that parts are missing or damaged , please within 7 days, preferably by email to contact us .

Table of Contents