Advertisement
Quick Links
Stoneridge DSRC Tester Manual
Stoneridge Electronics Ltd
Copyright
The information contained in this document is the property of Stoneridge
Electronics Ltd. and should not be reproduced, revealed or appropriated,
either in whole or in part, without the written authority of Stoneridge, Inc.
DD 56170 R02
1
© Stoneridge Electronics Ltd
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for Stoneridge DSRC Tester
- Page 1 The information contained in this document is the property of Stoneridge Electronics Ltd. and should not be reproduced, revealed or appropriated, either in whole or in part, without the written authority of Stoneridge, Inc. DD 56170 R02 © Stoneridge Electronics Ltd...
- Page 2 INTRODUCTION The Stoneridge DSRC Tester is a small hand held DSRC Transceiver intended to be used for reading DSRC tachograph data in stationary vehicles, by an operator. The DSRC tester is designed to operate from the internal battery for at least a full...
-
Page 3: Battery Charging
BATTERY CHARGING RSE622 is powered by a rechargeable Li-Ion battery. A USB charger and cable are included for charging the battery from a standard socket. The battery comes partially charged. Charge the battery for at least 3 hours before the first use of the RSE622. 2.1 OBU Reading Zones The longest reading range is achieved when OBU and Transceiver is pointing directly toward each other. -
Page 4: Hmi Functions
The RSE622 has a set of human-machine interfaces as described in the next paragraphs. 3.1 Push Button A light press on the push button will switch on the DSRC tester, it will respond with a blink, a beep and a short vibration. - Page 5 3.3 Sound The built in buzzer signals the following events: Event Sound signature RSE622 switched ON Short beep RSE622 switched OFF Three short beeps DSRC radio activated Short beep Reset to factory defaults Long beep OBU communication completed, transaction sent Short beep OBU communication timeout, no transaction Three short beeps...
- Page 6 4. Optimo – Connecting the DSRC Device – 1 Time Installation ▪ Open Windows Settings on Optimo by touching the Windows Key and selecting the Settings Cog, then select Devices and Bluetooth ▪ Select RSE622 and pair the device, the screen below will appear on completion of pairing ▪...
- Page 7 5. Optimo – Echo Test, Inspection Test and Installation Test ▪ Switch on the DSRC tester and the led on the unit will indicate green. Place your workshop card in the slot provided on Optimo, chip side downwards. Select the DSRC icon on the screen.
- Page 8 ▪ Select one of the tests, note that an Echo test is always performed by default no matter which test is selected ▪ Both Inspection test and Installation test show the same screens illustrated below. ▪ Inspection test is used during for a vehicle calibration. ▪...
- Page 9 ▪ Make sure your workshop card is in the card slot in Optimo, chip side down ▪ On selection of either test, Optimo will look for your workshop card as illustrated below ▪ On completion of the test the results screen below will be shown ▪...
Need help?
Do you have a question about the DSRC Tester and is the answer not in the manual?
Questions and answers