Advertisement
Quick Links
IN-DASH INSTALLATION KIT FOR SELECT
1982-UP CHEVROLET, DODGE, EAGLE,
GEO, HYUNDAI, LEXUS, MITSUBISHI,
SUZUKI & TOYOTA VEHICLES
CHEVROLET
SUZUKI
1998-01
Metro ---------------- 8
1996-98
1998-01
Tracker -------------- 8
TOYOTA
EAGLE
1990-95
1995-98
Talon ---------------- 8
1984-89
1997-01
GEO
1987-91
1995-97
Metro ---------------- 8
2000-05
1996-97
Tracker -------------- 8
1990-93
1993-97
Prizm ---------------- 8
1986-89
1989-92
Prizm ---------------- 9
HYUNDAI
1995-99
Accent -------------- 9
1993-97
1996-00
Elantra -------------- 9
1988-92
2000-01
Santa Fe ------------ 9
1995-96
Sonata -------------10
1988-92
LEXUS
1985-88
1996-97
LX450 --------------10
MITSUBISHI
2000-05
1995-99
Eclipse -------------- 8
2001-03
1992-95
Expo-LRV ----------10
2004-07
1996-97
SCION
2000-05
2004-06
xA ------------------10
1991-95
2008-UP xB ------------------11
2004-06
xB ------------------11
2008-UP xD ------------------11
CAR STEREO CONNECTORS
PROVIDE EASY CONNECTION OF YOUR CAR STEREO TO
FACTORY WIRING HARNESS.
EIM1F
ETA21F
1989-Up Geo Imports Vehicles
1982-Up Toyota Vehicles
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit in the listed vehicles.
Manufacturer cannot be held responsible for discrepancies/inconsistencies that may occur due to the
automobile manufacturing changes or options, or damage that may occur in the automobile during the
installation of components while using this booklet.
If you have any further questions, call our toll free technical help line at:
© 2009 SCOSCHE INDUSTRIES, INC.
e2 is a trademark of Scosche Industries, Inc.
EUI325F
TOYOTA (Suite)
1987-90
MR2 ---------------16
Sidekick ------------ 8
(Sport Coupe)
1989-95
Pickup -------------11
4-Runner -----------11
1984-88
Pickup -------------12
4-Runner -----------12
1991-97
Previa --------------16
Camry (Sedan) ----12
2004-05
RAV 4 --------------16
Camry -------------12
2000-03
RAV 4 --------------16
Celica
(Coupe)
-----12
1996-00
RAV 4 --------------17
Celica
(Liftback)
---13
2001
Sequoia ------------17
Celica, GT, ---------13
2000-01
Sienna -------------17
GTS, Liftback,
1998-01
Solara --------------12
Sport Coupe
1994-98
Supra---------------17
Corolla -------------13
1986½-93 Supra --------------18
Corolla, Sedan ----14
(Hatchback)
Console Location
1982-86
Supra---------------18
Corolla SR5--------14
1993-98
T-100 (Pickup) -----18
Sport Coupe
1995-04
Tacoma ------------18
Cressida ----------14
1995-98
Tercel ---------------18
Sedan/Wagon
1991-94
Tercel ---------------19
Echo ---------------14
1987-90
Tercel ---------------19
Highlander --------15
1983-86
Tercel ---------------19
Highlander --------15
2000-01
Tundra -------------17
Land Cruiser ------10
1999
Tundra -------------19
MR2 Spyder -------15
1984-86
Van -----------------19
MR2 ---------------15
(Sport Coupe)
1-800-621-3695x3
SI 1/09-EUI325F (3000523F)
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for e2 EUI325F
- Page 1 1-800-621-3695x3 If you have any further questions, call our toll free technical help line at: © 2009 SCOSCHE INDUSTRIES, INC. SI 1/09-EUI325F (3000523F) e2 is a trademark of Scosche Industries, Inc.
- Page 2 INTRODUCTION This premium installation kit is for 1982-08 selected Geo, Hyundai, Lexus, Mitsubishi and Toyota vehicles. Included are all the parts you need to mount your car stereo/cassette, or CD player into your vehicle’s dash. Refer to the individual instruction in this manual to remove your vehicle’s factory radio and assemble the kit.
- Page 3 REMOVING FACTORY BRACKETS REMOVE FACTORY MOUNTING BRACKETS: NOTE: The following steps are provided as a general guide. Your vehicle may differ. 1. Extract screws from the sides of the factory radio assembly and remove each side bracket. Do not mix up left and right side brackets. REMOVE FACTORY METAL...
- Page 4 MOUNTING THE STEREO PREPARING STEREO: REMOVE SLEEVE FROM STEREO 1. Locate the locking mechanism on your DIN stereo sleeve (typically) on the side. 2. Slip mounting sleeve towards rear of stereo and remove. MOUNTING THE STEREO 1. Mount the aftermarket stereo and pocket to the factory metal mounting car stereo using the factory hardware.
- Page 5 MOUNTING THE STEREO (Cont’d) SHAFT STEREO INSTALLATION WITH POCKET Using the hardware supplied with the stereo, secure the stereo chassis through the kit with the stereo’s faceplate on the front as shown. Using the ISO to shaft brackets (not included). FACTORY METAL MOUNTING BRACKET NOTE:...
- Page 6 • All factory wire locations are shown looking at the front of the plug with the wires exiting the rear. • Use the wiring codes as a guide. Your vehicle might differ. 1989-UP GEO IMPORTS (Use e2 EIM1F For Car Stereo Connector, sold separately) Power and Speaker 1 = Left Rear Positive 2 = Right Rear Positive...
- Page 7 FACTORY WIRE CODES (Cont’d) 1982-86 TOYOTA VEHICLES (Use e2 ETA21F For Car Stereo Connector, sold separately) Front Speaker and Power Plug 1 = Right Front Positive 2 = Left Front Positive 9-PIN 3 = +12V Ignition, Switched 4 = Power Antenna...
- Page 8 Read pages 2-7 1998-01 Chevrolet Metro for kit assembly. 1995-97 Geo Metro Radio Removal: 2442L BRACKET 1. Extract (2) screws from below heater controls. 2442L SUPPORT 2. Remove ash tray. Extract (2) screws from ash tray cavity. 3. Pull radio trim bezel out from dash and unscrew cigarette 2416 POCKET lighter collar from the back side.
- Page 9 1989-92 Geo Prizm Read pages 2-7 for kit assembly. Radio Removal: 2442L BRACKET 2442L SUPPORT 1. Remove one screw from the console/dash trim piece, located to the right of the ignition barrel. 2. Extract the single screw from the left side of the console/dash trim piece, located just below the air vent.
- Page 10 Read pages 2-7 1995-96 Hyundai Sonata for kit assembly. Radio Removal: NOTE: The factory radio provision is for a double DIN ISO style radio and pocket assembly that fi t behind the dash bezel. 2442L BRACKET 1. Carefully pry up on the gear shifter trim bezel with a panel 2442L SUPPORT removal tool to release the clips and remove.
- Page 11 Read pages 2-7 2004-06 Scion XB for kit assembly. Radio Removal: NOTE: The factory provision is a DIN and a HALF. 1. Pull off a/c knobs using PhilIips screwdriver . Extract (2) screws from a/c controls. 2442L TOYOTA BRACKET 2. Using panel removal tool, pop out lower portion of 2442L TOYOTA dash bezel then hinge outward to release.
- Page 12 Read pages 2-7 1984-89 Toyota 4-Runner for kit assembly. 1984-88 Toyota Pickup Radio Removal: 2442L TOYOTA BRACKET 1. Remove ashtray and (3) Phillips head sheet metal 2442L TOYOTA screws from ashtray cavity. SUPPORT 2. Remove (1) Phillips head sheet metal screw from each lower front side of radio trimpanel.
- Page 13 Read pages 2-7 1990-93 Toyota Celica (Liftback) for kit assembly. Radio Removal: 1. Snap off the shift lever boot/trim piece. 2. Extract (2) screws securing the lower edge of the radio trim piece. 2442L TOYOTA BRACKET 3. Carefully snap off the radio trim panel – begin prying 2442L TOYOTA SUPPORT with a panel removal tool along the top center of panel...
- Page 14 1988-92 Toyota Corolla Sedan Read pages 2-7 for kit assembly. (Sedan – Console Location) Radio Removal: 2442L TOYOTA BRACKET 2442L TOYOTA 1. Remove (2) Phillips head screws from the SUPPORT 2416 POCKET underside of the dash console trim, one at 2416 POCHE underside on the right side of the ignition switch and one at underside, just above left dash...
- Page 15 2004-07 Toyota Highlander Read pages 2-7 for kit assembly. Radio Removal: NOTE: The factory radio provision is for a Double Din size radio. 2442L TOYOTA BRACKET 2442L TOYOTA 1. Using a panel removal tool remove the trim SUPPORT around the radio and climate control bracket that holds the a/c vents.
- Page 16 Read pages 2-7 1987-90 Toyota MR2 (Sport Coupe) for kit assembly. Radio Removal: 1. Remove (2) #8 Phillips head sheet metal screws from top edge of radio trimpanel. 2442L TOYOTA BRACKET 2. Carefully release snaps located on bottom edge of 2442L TOYOTA trimpanel, disconnect wiring, and radio trimpanel.
- Page 17 Read pages 2-7 1996-00 Toyota RAV 4 for kit assembly. Radio Removal: NOTE: The factory radio provision is for an ISO DIN 2442L TOYOTA BRACKET 2442L TOYOTA radio that fi ts behind the dash bezel. SUUPORT 1. Extract (2) screws from below the radio. 2.
- Page 18 1986½-93 Toyota Supra (Hatchback) Read pages 2-7 Read pages 2-7 1991-94 Toyota Tercel for kit assembly. for kit assembly. 2442L TOYOTA BRACKET Radio Removal: Radio Removal: 2442L TOYOTA 1. Remove ashtray and remove (2) Phillips head 1. Unsnap and remove front bezel. (Snap on each 2442L TOYOTA BRACKET SUPPORT sheet metal screws from behind ashtray which...
Need help?
Do you have a question about the EUI325F and is the answer not in the manual?
Questions and answers