Suresafe SH-055U8W User Manual

ABOUT BATTERY
1.When the very right red LED lights up, it means the battery runs down. Connect the switching power
adaptor to continue the detecting and to recharge the battery at the same time.
2.It will take about 7 hours to full charge the battery under power off condition. If recharge under power on
condition, it will takes about 16 hours to full charge the battery.
3.If you are not going to use this device for a long time, please set the On/Off switch at Off and check the
battery power once three months.
SPECIFICATION
Detecting frequencies
50 MHz - 6.0 GHz
Dimension
L 14 x W 7 x T 2.5 cm
Weight
About 200 g
Power
12V DC 1A switching power adaptor
●
Built-in rechargeable battery pack
●
Battery life
Continuous for 2.5 days after full charge
Warning mode
Beep alarm sound
●
LED indication
●
Vibration
●
Earphone silent detection
●
Sensitivity Tuner
Adjust detecting distance to find signal
●
source
Eliminate the environment interference
●
Detecting Distance:
2.4GHz Wireless camera
about 35 feet (regular 10mW camera)
1.2GHz Wireless camera
about 40 feet (regular 10mW camera)
2G Cellular phone
about 50 feet (set at Analog)
Wired camera
about 15 feet
* Specifications may change without notice
NOTICE OF USE
When the battery runs down, If the switch is kept at "on", the battery will be over discharged and will
damage the battery.
Please set the on/off Switch at "off" and connect the switching power adaptor to charge this unit for 7
hours. Battery will be over charged if you keep on charging it without using that will also damage
battery. The producer accepts no liability for the damage caused by the over discharge or charge.
1. Unauthorized repair or dismantle of this device will void all the warranties.
2. Always use manufacturer's original power adaptor to avoid damage to the circuit.
3. Avoid water.
4. Do not store this device in an excessively hot place.
5. Avoid knock or drop of this device.
6. Never use the antenna of this device to touch a metal surface or the antenna of signal
emission source. The quality warranty does not include the damage caused by static
electricity or feedback.
Made in Taiwan.
WARNING
Use this device as an auxiliary, supplemental
help or aid to prevent the risks caused by hidden
camera, cellular phone or other wireless devices.
This device does not take the place of all the
supervisions. Performance of this Radio
frequency (RF) product will be affected by the
circumstance of use. The producer and
marketing group accepts no liability for any loss
or damage by malfunction or misuse.
COPYRIGHT
No part of this manual may be reproduced,
transmitted, transcribed, or translated into any
language in any form by any means, electrical or
mechanical, including photocopying, recording,
or information and retrieval systems, without the
express written permission of manufacturer.
Products mentioned in this manual are for
identification purposes only. All brand names
appearing in this manual may or may not be
registered trademarks or copyrights of their
respective companies. The manufacturer
reserves the right to change or modify the
specifications of any one or all of these products
as deemed necessary at any time without prior
notification. The manufacturer may further
revise this manual from time to time without
prior notice.
Copyright 2000-2010. All rights reserved.
55U8WPK1A
08.2010
SH-055U8W
Superior sensitivity
RF Signal Detector with Digit sensitivity display
Adds hard wire camera detection
Thank you for purchasing the Suresafe
Detector. Please first read over this manual for proper use, save this manual
and keep it handy.
GENERAL
This device applies with fuzzy scanning
technology to detect spy cameras, bugs,
cellular phones and other radio frequency
devices. This device surely avoids being
peeped or tapped to protect privacy or
protect information from being disclosed
secretly.
This new model applies digit (numeric)
display to show the sensitivity level. With
up (▲) and down (▼) buttons, user knows
the sensitivity setting directly.
Every time the detector is switched on, it
will back to factory default benchmark. You
will have no more confusion of too high or
too low sensitivity setting if forgot to re-set
the sensitivity.
SH-055U8W is easy for you to find suitable
benchmark. Press the UP or DOWN button in the side
of detector, leave only the very left LED going Green
and no alarm go off, this is the suitable benchmark.
SH-055U8W has built-in rechargeable battery pack.
When the battery runs down, the very right LED will
go red to notify you to recharge the unit.
User's Manual
RF (Radio Frequency) Signal
Wired camera
detection switch
On/Off switch
(Power input)
(Up)
(Down)
(Earphone)