Summary of Contents for Radioddity voyage Rv6
- Page 1 A Better Store User Manual Marine VHF radio VOL SQL MONI www.radiaddity.com SCAN Hi Lo DUAL Radiod ity voyage Rv6...
- Page 2 NEVER connect the transceiver to an AC outlet, this may pose a fire hazard or result in an electric shock. not offer quality goods, service and advice. At Radioddity.com, you do not have to choose between low prices and a secure shopping experience. Whether you are buying from us for the first time or a seasoned DO NOT use or place the transceiver in direct sunlight or in areas With temperatures below-15℃...
- Page 3 The radio floats in fresh or salt water when the supplied accessories what's in the box are attached. Scanning...
- Page 4 Note: lf the battery cover is not covered better, the radio may leak water what’s in the box from here. Thanks for choosing Radioddity marine VHF radio. We recommend you At the back of the radio there are two paralleI screws to check the items listed in the following table before discarding the mounted above the battery, remove these and thread package.
- Page 5 While in the setting mode,pushtoselectthesettingorvalueofanitem. Hold and turn radio ON to selected ANTENNA NOTE: Ensure the cap for the DC charging connector is affixed correctly to avoid water ingress. Press this button again to turn off the function. Press this button again to turn off the function.
- Page 6 Each regular channel group has separate leisure-use call channels. The call channel is monitored during tri-watch. The call The selectable channel groups are different, depending on channels can be programmed and are used to store your most the version. frequently used channel in each channel group for quick recall. DUP appears when a duplex channel is selected.
- Page 7 Note: The mute function refers to the transmit and receive volume，the mute function is activated，and the button sound is not affected. activate flash Scanning When a signal is received, the scan pauses until the signal Push [VOL/SQL] to turn it off. disappears or resumes after pausing 5 seconds, depending on the set mode setting.
- Page 8 The set mode is used to channel the settings of the transceiver’s functions: beep tone function, priority scan function, scan resume timer, auto scan function, dual/tri-watch function, monitor key action, automatic backlighting, LCD contrast setting and power save function. transceiver.
- Page 9 remains open inactivity. The power save function reduces current drain by turning OFF the receiver circuit for preset intervals.
- Page 10 programming. TX: 156.025 – 157.425MHz RX: 156.000 – 163.425MHz...